Bissoy.com
Doctors Medicines MCQs Q&A

What are the temperature and pressure conditions for the compression moulding of m-f resin?

What are the temperature and pressure conditions for the compression moulding of m-f resin? Correct Answer 150-170 C and 2000-8000 psi

The temperatures in the range of 150-170 C and pressure of the order 2000-8000 psi are employed for compression moulding of m-f resins.

Related Questions

What are the temperature and pressure conditions in compression moulding technique in the moulding of phenolic moulding powder?
Resin P, on further heating turns into completely cross-linked resin Q, which is totally insoluble and infusible. Resin P is slightly heat fusible and insoluble in alkalis and alcohols but partly soluble in acetone. What are the names of resin P and Q?
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
Co2 moulding is a kind of sand moulding, but it is not economical than the green sand moulding.
Match the following in Column X with Column Y: Column X Column Y  P. In a triaxial compression test, with increase of axial strain in loose sand under drained shear condition, the volumetric strain  I. decreases  Q. In a triaxial compression test, with increase of axial strain in loose sand under undrained shear condition, the excess pore water pressure  II. Increase  R. In a triaxial compression test, the pore pressure parameter “B” for a saturated soil  III. remains same  S. For shallow strip footing in pure saturated clay, Terzaghi’s bearing capacity factor (Nq) due to surcharge  IV. is always 0.0.      V. is always 1.0.      VI. is always 0.5. Which one of the following combinations is correct?
In vapor compression cycle having dry saturated vapor at the end of compression the work done is given by? H2 – Enthalpy of vapor after compression H1 – Enthalpy of vapor before compression
In vapor compression cycle having dry saturated vapor at the end of compression the refrigeration effect is given by? H1 – Enthalpy of vapor before compression H4 – Enthalpy of vapor before entering evaporator H2 – Enthalpy of vapor after compression
Consider the following statements and choose the correct answer:
1. A direct proportionality exists between vapour pressure and the concentration of water vapour in the atmosphere
2. Relative humidity is an expression of the ratio of the actual vapour pressure of the atmosphere when saturated at the same temperature
3. A rise or fall in temperature with no change in vapour pressure will cause a drop or rise, respectively, in relative humidity
4. A rise or fall in vapour pressure with no change in temperature will be accompanied by a rise or fall, respectively, in relative humidity
For a two stage reciprocating compressor, compression from p₁ to p₃ is with perfect intercooling and no pressure losses. If compression in both the cylinders follows the same polytropic process and the atmospheric pressure is pa, then the intermediate pressure p₂ is given by
For a two stage reciprocating compressor, compression from p1 to p3 is with perfect intercooling and no pressure losses. If compression in both the cylinders follows the same polytropic process and the atmospheric pressure is pa, then the intermediate pressure p2 is given by