Bissoy.com
Doctors Medicines MCQs Q&A

The reactor loading process is a method of adsorption.

The reactor loading process is a method of adsorption. Correct Answer True

The reactor loading process is a method of adsorption where the carrier is placed in the reactor and then enzyme/cell is transferred to the reactor. Other methods of adsorption include static process, dynamic batch process, and electrode position process.

Related Questions

Though, theoretically the adsorption & desorption isotherms is expected to coincide but sometimes at least a part of the isotherms does not coincide and this phenomenon is known as adsorption hysterisis. In such cases, the desorption equilibrium pressure is __________ that obtained for adsorption.
Though, theoretically the adsorption & desorption isotherms is expected to coincide but sometimes at least a part of the isotherms does not coincide and this phenomenon is known as adsorption hysterisis. In such cases, the desorption equilibrium pressure is __________ that obtained for adsorption.
What type of reactor is used in Tarapur atomic power plant? a. Molten salt reactor b. Boiling water reactor c. Fast neutron reactor d. None of these
A Composition of carbon dioxide, oxygen and nitrogen with mole ratio 1:2:5 with 4 moles of oxygen, enters a reactor with a flow rate of 100 kg/s, the ratio of rates of leaving the reactor of the three is 5:2:1, and 5 moles of nitrogen leaves the reactor, what is the total number of moles leaving the reactor?
A reactor having a salvage value of Rs. 10000 is estimated to have a service life of 10 years. The annual interest rate is 10%. The original cost of the reactor was Rs. 80000. The book value of the reactor after 5 years using sinking fund depreciation method will be Rs.
Consider the following statements: 1. The chain reaction process is used in nuclear bombs to release a vast amount of energy, but in nuclear reactors, there is no chain reaction. 2. In a nuclear reactor, the reaction is controlled, while in nuclear bombs, the reaction is uncontrolled. 3. In a nuclear reactor, all operating reactors are ‘critical’, while there is no question of ‘criticality’ in case of a nuclear bomb. 4. Nuclear reactors do not use moderators, while nuclear bombs use them. Which of the above statements about operational principles of a nuclear reactor and a nuclear bomb is / are correct?
In which of the following reactor it is possible to add remove and process the reactor fuel during reactor operation?
The fresh feed to an ammonia synthesis reactor contains nitrogen, hydrogen and 2.0 mole per cent inerts. The molar ratio of H2:N2 is 3:1. The product stream consists of pure ammonia. Since conversion in the reactor is only 15%, a recycle stream is used and in order to avoid build-up of inerts, a purge stream is withdrawn. The rate of purge stream is adjusted to keep inert concentration in the recycle stream at 8 mole per cent. For a fresh feed rate of 100 moles/hr. Note that recycle stream contains only nitrogen, hydrogen and inerts. The N2:H2 ratio of 1:3 is maintained in every process stream, and calculate the moles of nitrogen entering the reactor and in the recycle stream?
Consider the following statements.
1. The chain reaction process is used in nuclear bombs to release a vast amount of energy, but in nuclear reactors, there is no chain reaction.
2. In a nuclear reactor, the reaction is controlled, while in nuclear bombs, the reaction is uncontrolled.
3. In a nuclear reactor, all operating reactors are 'critical', while there is no question of 'critically' in case of a nuclear bomb.
4. Nuclear reactors do not use moderators, while nuclear bombs use them.
Which of the above statements about operational principles of a nuclear reactor and a nuclear bomb is/are correct?
Which adsorption method is the primary mechanism of adsorption in air pollutant control?