Bissoy.com
Doctors Medicines MCQs Q&A

The sterilization in double spiral heat exchanger is done through ___________

The sterilization in double spiral heat exchanger is done through ___________ Correct Answer Countercurrent mechanism

The sterilization in a double spiral heat exchanger is done through Countercurrent mechanism where steam is passed through one spiral and the medium is passed through the other spiral.

Related Questions

Which of the following statements about Printed circuit heat exchanger are correct? Statement 1: Printed circuit heat exchanger is an example for direct heat exchanger. Statement 2: It has high heat transfer surface area per unit volume of the exchanger.
Consider the following statements: The axis of spiral bevel gear are non-parallel and intersecting. 1) The most common pressure angle for spiral bevel gear is 20° 2) The most common spiral angle for spiral bevel gear is 35. 3) Spirals bevel gears are generally interchangeable. 4) Spirals are noisy and recommended for low speeds of 10 m /s. Which of the above statements are correct?
Forced air flows over a convection heat exchanger in a room heater, resulting in a convective heat transfer coefficient 1.136 k W/m2 K. The surface temperature of heat exchanger may be considered constant at 65 degree Celsius, and the air is at 20 degree Celsius. Determine the heat exchanger surface area required for 8.8 k W of heating
Plate type heat exchangers have less surface area as compared to a similar Shell and Tube heat exchanger. A Shell and Tube Heat Exchanger of equivalent area weigh six-seven times less than a Plate Type heat exchanger.
Which of the following statements about sterilization are correct? Statement 1: Sterilization is achieved by a heat and chemicals alone. Statement 2: Ultraviolet radiation cannot be used for sterilization.
In a surface condenser, the water flowing through a series of tubes at the rate of 200 kg/hr is heated from 15 degree Celsius to 75 degree Celsius. The steam condenses on the outside surface of tubes at atmospheric pressure and the overall heat transfer coefficient is estimated at 860 k J/m2 hr degree. Find the effectiveness of the heat exchanger. At the condensing pressure, stream has a saturation temperature 0f 100 degree Celsius and the latent heat of vaporization is 2160 k J/kg. Further, the steam is initially just saturated and the condensate leaves the exchanger without sub-cooling i.e. only latent heat of condensing steam is transferred to the water. Take specific heat of water as 4 k J/kg K
In a surface condenser, the water flowing through a series of tubes at the rate of 200 kg/hr is heated from 15 degree Celsius to 75 degree Celsius. The steam condenses on the outside surface of tubes at atmospheric pressure and the overall heat transfer coefficient is estimated at 860 k J/m2 hr degree. Find the number of transfer units of the heat exchanger. At the condensing pressure, stream has saturation temperature 0f 100 degree Celsius and the latent heat of vaporization is 2160 k J/kg. Further, the steam is initially just saturated and the condensate leaves the exchanger without sub-cooling i.e. only latent heat of condensing steam is transferred to water. Take specific heat of water as 4 k J/kg K
If all the conditions and dimensions are same, then the ratio of velocity through the tubes of a double pass heat exchanger to that through the single pass heat exchanger is
Are these statements about the sterilization true? Statement 1: Sterilization process consists of 3 phases. Statement 2:Phase 2 in sterilization process is known as holding phase.
A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as