Related Questions

The crack propagation rate with stress is given as ______ Where; -> da/dN is crack growth with each cycle -> C is constant -> σm is mean stress -> σa is alternating stress -> a is the crack length -> m and n are constant
The young’s modulus of the steel is 600 MPa, and the plastic stress required to extend the crack is 50*10-9, and the initial crack length is 2 microns. Find the fracture stress required to crack the material?
How many of the following statements are correct? i) All cyclic graphs are complete graphs. ii) All complete graphs are cyclic graphs. iii) All paths are bipartite. iv) All cyclic graphs are bipartite. v) There are cyclic graphs which are complete.
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
According to Irwin’s correction of plasticity at the crack tip, the sufficient crack length is given as the actual crack length plus the radius of the plastic zone. The radius of the plastic zone (rp) in case of plane stress is given as ________
The hydrostatic stress influence the crack propagation but not the crack initiation.
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
Which of the following statements regarding stress related factors is/are true and false?
1. Burnout Stress Syndrome (BOSS) is a debilirating psychological condition brought about by unrelieved work stress.
2. 'Good' and 'bad' stresses are also referred to as 'Distress' and 'Eustress' respectively.
3. It is natural and healthy to maintain optimal level of stress.
4. Rustout Stress Syndrome (ROSS) is indicative of stress overload.
5. Anxiety is a state of emotional tension characterised by Apprehension, fearfulness, and psychic pain.
According to Irwin’s correction of plasticity at the crack tip, the effective crack length is given as the actual crack length plus the radius of the plastic zone. The radius of the plastic zone (rp) in case of plane strain is given as ________
Fracture stress for a brittle material having a crack lenght of 1μm is 200 MPa. Fracture stress for the same material having a crack lenght of 4 μm is