Bissoy.com
Doctors Medicines MCQs Q&A

Dislocations generate on _____ under applied stress.

Dislocations generate on _____ under applied stress. Correct Answer planes with Frank-Read source

Dislocation generation takes place on planes with Frank-Read source. These sources produce dislocation loops on application of stress. It can be understood by Frank-Read source mechanism.

Related Questions

Which of the following statements are true about edge dislocations?
P. Edge dislocations do not have an extra half plane associated with them.
Q. The Burger vectors is perpendicular to the direction.
R. Edge dislocations can avoid obstacles by cross-slip.
S. Depending on geometry, parallel edge dislocations of opposite signs can attract or repel one another.
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
Edge dislocations have _____ stress field therefore _____ interactions can occur between parallel edge dislocations.
Screw dislocations with jogs are __________ mobile than edge dislocations. Screw dislocations without jog move __________ from one plane to another than edge dislocation.
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
Which of the following statements regarding stress related factors is/are true and false?
1. Burnout Stress Syndrome (BOSS) is a debilirating psychological condition brought about by unrelieved work stress.
2. 'Good' and 'bad' stresses are also referred to as 'Distress' and 'Eustress' respectively.
3. It is natural and healthy to maintain optimal level of stress.
4. Rustout Stress Syndrome (ROSS) is indicative of stress overload.
5. Anxiety is a state of emotional tension characterised by Apprehension, fearfulness, and psychic pain.
Which of the following statement(s) is/are CORRECT? I. Acids are sour in taste and generate H+ ions. II. Acids are sour in taste and generate OH- ions. III. Bases are bitter in taste and generate OH- ions.
Which of the following statement(s) is/are CORRECT? I. Acids are sour in taste and generate H+ ions. II. Acids are sour in taste and generate OH– ions. III. Bases are bitter intaste and generate OH– ions.
The dislocations in the material only act as strong obstacles to the movement of other dislocations.