Bissoy.com
Doctors Medicines MCQs Q&A

Nucleation in solids, as in liquids, in most cases is always __________

Nucleation in solids, as in liquids, in most cases is always __________ Correct Answer Heterogeneous

This is the scenario found in most cases because they prefer the non-equilibrium defects as there nucleation sites, in many cases it occurs in the grain boundaries, excess vacancies and in the stacking faults.

Related Questions

Two statements are given followed by three conclusions numbered I, II and III. Assuming the statements to be true, even if they seem to be at variance with commonly known facts, decide which of the conclusions logically follow(s) from the statements. Statements: All liquids are solids. All gases are solids. Conclusions: I. Some solids are liquids. II. Some liquids are gases. III. No liquid is gas.
Which of the following is true? 1. The rate of diffusion of liquids is higher than that of solids. 2. Gases are highly compressible as compared to solids and liquids. Choose the correct code.
At very small driving forces, when activation energy barriers for nucleation are high, the highest nucleation rates will be produced by grain corner nucleation.
Consider the following statements regarding removal of impurities from water: 1. Settleable solids are removed by filtration. 2. Volatile solids are removed through sedimentation. 3. Dissolved solids are removed through reverse osmosis. 4. Colloidal solids are removed by coagulation. Which of the above statements are correct?
In a batch process, the reaction takes place in the presence of an acid medium. The acid is drained from the reaction vessel at the rate of 15ml/s as a result of the density difference of the acid from the reacting component. To avoid wastage of acid, it is recycled to an acid tank which has 1000 L capacity. The acid drained from the reaction vessel, picks up 50 g/L solids from the reactor. Acid is fed once again to the process from acid tank. When the process is started, the acid is almost pure in the tank as a result of filtration. As the reaction proceeds, acid in the tank gets more and more contaminated with the solids. The concentration of the solids should not exceed 100 g/L from the process point of view. The batch time is 16h. Estimate whether the concentration of the solids will exceed 100g/L during the batch reaction.
During the reactivity of solids, two stages that may usually be identified are Nucleation of the product and its subsequent growth. When is nucleation facilitated?
A bottle contained a mixture of two liquids A and B in the ratio 11 ∶ 4. When 30 ml of the mixture is replaced with 15 ml of another mixture of the two liquids in ratio 7 ∶ 8, the ratio of the liquids in the final mixture becomes 2 ∶ 1. What is the quantity of final mixture in the bottle?
A container has a mixture of liquids A and B. The ratio of liquids A to B is 4 : 5. How much mixture must be taken out of the container and replaced with liquid A so that the final mixture should contain liquids A and B in ratio 1 : 1?
Two statements are given, followed by four conclusions numbered I, II, III, IV. Assuming that the information given in the statements is true, even if it appears to be at variance with commonly known facts, decide which of the given conclusions logically follow(s) from the statements. Statements: No lotion is a syrup. All syrups are liquids. Conclusions: 1. No lotion is a liquid. 2. No liquid is a lotion. 3. Some liquids are syrups. 4. All liquids are syrups.
Read the given statements and conclusions carefully and select which of the conclusions follow(s) from the statements. Statements: I. All liquids are fluid. II. All fluids are viscous. Conclusions: I. All viscous are liquids. II. All liquids are viscous.