Bissoy.com
Doctors Medicines MCQs Q&A

Taper boring and the under boring can be performed by______

Taper boring and the under boring can be performed by______ Correct Answer face plates or angle plates

Both types of plates can be used for this purpose. A face plate consists of a circular disk bored out and threaded to sit the nose of the lathe spindle while angel plate is a cast iron plate having two faces machined to make them absolutely at right angles to each other.

Related Questions

Reaming and counter boring can be performed by______
Which of the following option is correct for given statements about plug gauges for self-holding tapers? Statement 1: Plug is inserted with high pressure for checking taper. Statement 2: Morse taper is a type of self-holding taper.
The following statements are made regarding the Open Circuit Test on the single-phase transformer: 1. It is performed on the LV side. 2. It is performed at rated current. 3. It helps in the calculation of equivalent leakage impedance. 4. It is performed on the HV side. 5. It is performed at rated voltage. 6. It gives magnetizing current and core loss. 7. It helps in the determination of voltage regulation. 8. It gives the turn ratio. From these, which statements are correct?
Consider the following statements about the doctrine of frustration:
1. Act has become impossible to be performed.
2. Act cannot be performed because of application of some law recently enacted.
3. Act cannot be performed because of the non-availability of raw material.
4. Act cannot be performed by defendant due to his accident.
Which of the statements given above are correct?
Grinding can be performed by______
The taper can be turned up to maximum setting angle of_____ for both outside and inside tapers with taper attachment and automatic feed.
Determine the corrections or otherwise of the following assertion and reason : Assertion : Taper ratio will affect the weight of wing. Reason: For finite taper ratio, wing thickness will be different at root and tip. and are true and is the correct reason for b) Both and are true but is not the correct reason for c) is true but is false d) is false but is true
A displacement sensor (a dial indicator) measures the lateral displacement of a mandrel mounted on the taper hole inside a drill spindle. The mandrel axis is an extension of the drill spindle taper hole axis and the protruding portion of the mandrel surface is perfectly cylindrical measurements are taken with the sensor placed at two positions P and Q as shown in the figure. The readings are recorded as Rx = maximum deflection minus minimum deflection, corresponding to sensor position at X, over one rotation. If RP = RQ > 0, which one of the following would be consistent with the observation?
The larger diameter of shaft is 125 mm and smaller diameter of the shaft is 95 mm. Find the taper. Assume that length of the job and taper is same.
Suppose the given statements are true when they seem to be different from the commonly known facts and decide which of the conclusions completely follows the statement. Statement: To get involved in a long and complicated dispute, one has to be very intelligent, because they are very talkative and boring. Conclusions: I. All intelligent people are boring. II. All intelligent people are quite capable of handling long and complicated disputes.