Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the given question and decide which of the following statements is sufficient to answer the question. What is the colour of the granite in the kitchen? Statements: 1. The colour of the granite is the colour of the wall. 2. The colour of the granite is very bright.
In the question three statements are given, followed by three conclusions, I, II and III. You have to consider the statements to be true even if it seems to be at variance from commonly known facts. You have to decide which of the given conclusions, if any, follows from the given statements. Statement I: No marble is granite. Statement II: All stones are marble. Statement III: Some rocks are stones. Conclusion I: Some rocks are granite. Conclusion II: Some marble are rocks. Conclusion III: No stones are granite.
Consider the given question and decide which of the following statements is sufficient to answer the question. What is the colour of the granite in the kitchen? Statements :
1. The colour of the granite is the colour of the wall.
2. The colour of the granite is very bright.
What is the colour of the granite in the kitchen? Statements: 1. The colour of the granite is the colour of the wall. 2. The colour of the granite is very bright.
At the mould exit of a continuous caster, the metal consisting of a solidified shell with a liquid metal core exits at the rate of 35 kg S-1. Given that the latent heat of fusion is 3 × 105 J kg-1 and the total rate of heat removal by the mould is 4.2 × 106 W, the mass fraction of solid at the mould exit is . . . . . . . .
Assume that both while solid and liquid remain at the melting point, they are in the mould.
Co2 moulding is a kind of sand moulding, but it is not economical than the green sand moulding.
What are the temperature and pressure conditions in compression moulding technique in the moulding of phenolic moulding powder?
Cores can be made within the mould by using moulding sand which is used for mould preparation.
The three mould technique is generally preferred than the two mould technique in injection moulding process.
When a pattern is to be withdrawn from the mould, it is first shaken, by striking over it from side to side, so that its surface may be free of the adjoining sand wall of the mould. That causes the size of the mould cavity increases a little and a negative allowance is to be provided in the pattern to compensate the same, is known as: