Bissoy.com
Doctors Medicines MCQs Q&A

PPM defectives can be a measure of the process capability. Although an equivalent sigma level can also be used.

PPM defectives can be a measure of the process capability. Although an equivalent sigma level can also be used. Correct Answer True

As a particular sigma level shows a particular amount of defectives, e.g. 2700 ppm is equivalent to a 3-sigma process; an equivalent sigma level can be used instead of using the ppm defectives as a measure of the process capability.

Related Questions

Rock mass parameters for a shale rock, mb, s, and a of the Hoek and Brown failure criterion as given in the equation are 2.4, 0.01 and 0.52 respectively. The uni-axial compressive strength (σCi) of intact sh!le is 50 MPa.
$${\sigma _1} = {\sigma _3} + {\sigma _{ci}}{\left( {{m_b}\frac{{{\sigma _3}}}{{{\sigma _{ci}}}} + S} \right)^a}$$
The global rock mass strength of shale in MPa is
The treatment system includes a WAC, SAC, followed by a WBA and SBA. There is a degasser in this system. Calculate the amount of SBA resin required for the following data. M Alkalinity: 100 ppm as CaCO3 P Alkalinity: 100 ppm as CaCO3 Silica: 30 ppm as CaCO3 CO2: 45 ppm as CaCO3 EMA: 100 ppm as CaCO3 Capacity: 37 Kg/m3 Correction factor: 0.9 Flow rate: 35 m3/hr Operation hours: 10 hrs
To construct an operating characteristic curve, an agreement has to be reached between producer and consumer through which of the following points? 1. Maximum proportion of defectives that will make the lot definitely unacceptable 2. The producer is willing to accept that some of satisfying the quality level (AQL) will be rejected (α = 5%) 3. Maximum level of percentage defectives that will make the lot definitely unacceptable 4. The consumer is willing to take lots of quality level (LTPD) even though they are unacceptable (β = 10%)
Following is an ecosystem of water-body, showing the concentration of DDT in each trophic levels. Water →  Algae → Fish → Pelican bird 1700 ppm → 500-600 ppm → 77 ppm → 0.2 ppm Which of the following feature is incorrect if the above is to represent biomagnification?
The treatment system includes a WAC, SAC, followed by a WBA and SBA. There is no degasser in this system. Calculate the amount of resin required for the following information. M Alkalinity: 100 ppm as CaCO3 P Alkalinity: 100 ppm as CaCO3 Silica: 45 ppm as CaCO3 CO2: 45 ppm as CaCO3 Capacity: 37 Kg/m3 Correction factor: 0.9 Flow rate: 35 m3/hr Operation hours: 10 hrs
A company paid Rs. 6,00,000 as bonus to its employees at different levels A, B and C. Each employee at level A receives one and half times of the amount that was paid to each employee at level B and each employee at level B was paid twice the amount paid to the employee at level C. If 50 employees were on level A, 75 on level B and 100 on level C, how much amount was paid to each employee of level A ?
Consider the following statements.  I. Pi-Bond is stronger than the Sigma Bond.  II. Sigma Bond is formed by linear overlapping of atomic orbitals.  III. In the case of Pi-Bond, the extent of overlapping of atomic orbitals is more as compared to the Sigma Bond.  Which among the above is/are NOT correct?
Calculate the SAC resin required for the following data. It should be noted that prior to the SAC, a WAC system is present. M Alkalinity: 100 ppm as CaCO3 P Alkalinity: 100 ppm as CaCO3 EMA: 50 ppm as CaCO3 Capacity: 57 Kg/m3 Correction factor: 0.9 Flow rate: 135 m3/hr Operation hours: 20 hrs
The treatment system consists of a WAC, SAC which is followed by a WBA and SBA. Calculate the amount of WBA resin required for the following data. M Alkalinity: 100 ppm as CaCO3 P Alkalinity: 100 ppm as CaCO3 EMA: 25 ppm as CaCO3 Capacity: 37 Kg/m3 Correction factor: 0.9 Flow rate: 135 m3/hr Operation hours: 20 hrs
If beginning work in process equivalent units are 2500 units, work done in current period equivalent units are 3800 units and ending work in process equivalent units are 5000, then complete equivalent units in current period are