Bissoy.com
Doctors Medicines MCQs Q&A

Dry compression is preferred over wet compression.

Dry compression is preferred over wet compression. Correct Answer True

Dry compression is preferred over wet compression since it gives high volumetric efficiency and mechanical efficiency of the compressor with less chances of damage to it. However, in some cases wet compression is preferred when the compression is done using a screw or rotary compressor.

Related Questions

Consider the following statements regarding clutches 1. Dry clutch has higher coefficient of friction compared to wet clutch 2. The torque capacity of wet clutch is high compared to dry clutch. 3. The engagement in a dry clutch is smoother than in case of wet clutch. Which of the above statements is/are correct ?
In a laboratory test run, the rate of drying was found to be 0.5 × 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is
The wet bulb temperature is lower in dry air than in wet air at the same temperature. A dry bulb thermometer registers a higher temperature than a wet bulb thermometer except at __________ percent relative humidity.
Wet compression is preferred over dry compression.
Simplify : $${{{5 \over 3} \times {7 \over {51}}{\text{ of }}{{17} \over 5} - {1 \over 3}} \over {{2 \over 9} \times {5 \over 7}{\text{ of }}{{28} \over 5} - {2 \over 3}}}$$
Match List-I with List-II and select the correct answer using the code given below the Lists: List I (Low-Latitude Climate) List I (Characteristic) A. Wet Equatorial 1. Uniform temperatures, mean near 27°C  B. Monsoon and trade wind coastal 2. Marked temperature cycle with very high temperature before the rainy season C. Wet-dry tropical  3. Temperatures show an annual cycle with a high temperature in the high-Sun season Strong temperature cycle. with intense temperature during the high-Sun season  D. Dry tropical 4. Strong temperature cycle, with intense temperature during the high-Sun season
In vapor compression cycle having dry saturated vapor at the end of compression the work done is given by? H2 – Enthalpy of vapor after compression H1 – Enthalpy of vapor before compression
In vapor compression cycle having dry saturated vapor at the end of compression the refrigeration effect is given by? H1 – Enthalpy of vapor before compression H4 – Enthalpy of vapor before entering evaporator H2 – Enthalpy of vapor after compression
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
The color preferences of a group of girls were mapped and the results were as follows: 20 preferred pink, 16 preferred red and 14 preferred green. 5 preferred all the three colours. 9 of them chose Pink and Green. 7 of them chose Pink and Red. 8 of them chose Red and Green. How many girls chose only one colour?