Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following is not a factor for explosive welding?

Which of the following is not a factor for explosive welding? Correct Answer Less amount of plastics

While considering for explosive welding, the factors that one needs to understand is that, there has to be high relative velocity. There should be proper orientation and it needs to be kept under high amount of pressure.

Related Questions

Which of the following statement(s) is/are true regarding butt welding? 1. Flash butt welding is a combination of resistance, arc and pressure welding 2. Upset butt welding is used for welding rods 3. Percussion Welding is a self timing spot welding method 4. Aluminium alloys are flash welded
Which two of the following joining processes are autogenous? i. Diffusion welding ii. Electroslag welding iii. Tungsten inert gas welding iv. Friction welding
In an overburden bench of an iron ore mine the following data were found:
Height = 10m
Burden = 4m
Spacing = 3m
Sub-grade drilling length = 1m
Collar stemming length = 3m
If the diameter of the explosive column is 150 mm and the specific gravity of explosive and that of rock are 0.9 and 2.4 respectively, the powder factor in te/kg will be
The power source in a particular welding setup generates 4000 W that can be transferred to the work surface with a heat transfer factor = 0.9. The metal to be welded is low carbon steel, whose melting temperature, is 1800 K. The melting factor in the operation is 0.6. A continuous fillet weld is to be made with a cross-sectional area = 20 mm2. Determine the travel speed at which the welding operation can be accomplished? (K = 3.33 *10-6)
The government has sent out a stern warning to WhatsApp asking the Facebook-owned messaging platform to immediately stop the spread of irresponsible and explosive messages filled with rumours and provocation through the application of appropriate technology. In a statement, the ministry of electronics and IT said on Tuesday, instances of lynching of innocent people have been noticed recently because of large number of irresponsible and explosive messages filled with rumours and provocation are being circulated on WhatsApp. Which of the following can be logically inferred from the statement above?
Consider the following in case of high-energy forming processes: 1. The evacuation between die and blank in explosive forming is done by a vacuum pump. 2. The pressure waves produced in water in explosive forming deform the blank to the die shape. 3. The electrohydraulic forming makes use of discharge of large amount of electrical energy used in a capacitor bank. 4. In Petroforge, the piston is moved by combustion of fuel moving at the rate of 150-200 m/s. Which of the above are correct?
Consider the following statements: In metal arc welding 1. Utilizes a consumable electrode 2. A welding torch used is connected to acetylene gas supply 3. The electrode and work-piece are connected to the welding power supply. Which of these statements are correct?
Consider the following statements in respect of the oxidizing flame due to excess oxygen in welding: 1) AT high temperature, it combines with many metals to form hard and brittle oxides. 2) It causes the weld bead and the surrounding area to have a scummy appearance 3) It has good welding effect in welding of copper-base metal. Which of the above statements are correct?
The widest explosive limit is of __________ , thereby making it the most explosive gas.
Where was RaIDer-X, a new explosive detection device, unveiled at the National Workshop on Explosive Detection (NWED-2020) in March 2020?