Bissoy.com
Doctors Medicines MCQs Q&A

Pulling each roving separately through an orifice is an alternative way for wiping the resin-impregnated rovings in the filament winding process.

Pulling each roving separately through an orifice is an alternative way for wiping the resin-impregnated rovings in the filament winding process. Correct Answer True

This technique provides better control of resin content compared to the wiping device technique. But the probability of the fiber breakage increases and it becomes difficult to rethread the broken roving line through its orifice.

Related Questions

The discharge through a small rectangular orifice is given by (where Cd = Coefficient of discharge for the orifice, a = Cross-sectional area of the orifice, h = Height of the liquid above the centre of the orifice)
The discharge through a wholly drowned orifice is given by (where H1 = Height of water (on the upstream side) above the top of the orifice, H2 = Height of water (on the downstream side) above the bottom of the orifice and H = Difference between two water levels on either side of the orifice)
The discharge through a small rectangular orifice is given by (where Cd = Coefficient of discharge for the orifice, a = Cross-sectional area of the orifice, h = Height of the liquid above the centre of the orifice)
The discharge through a large rectangular orifice is given by (where H1 = Height of the liquid above the top of the orifice, H2 = Height of the liquid above the bottom of the orifice, b = Breadth of the orifice and Cd = Coefficient of discharge)
A rectangular orifice of 2 m width and 1.2 m deep is fitted in one side of large tank. The easier level on one side of the orifice is 3m above the top edge of the orifice while on the other side of the orifice the water level is 0.5 m below it’s top edge. Calculate discharge if Cd = .64
____________ controls the resin coating thickness around each roving and removes the excess resin from the rovings.
Distributed winding is a type of winding in electrical machines where all the winding turns are arranged in a number of full pitches or fractional pitches. These coils are then placed in phase form or the commutator winding in slots spread around the periphery of the air gap. This type of winding used in
The discharge through fully submerged orifice is -  Where, H = Difference in level of water H1 = Height of water above the top of the orifice on the upstream side H2 = Height of water above the bottom of the orifice
Find the discharge through totally drowned orifice of width 2.3 m if the difference of water levels on both side of the orifice be 40 cm. The height of water from to and bottom of the orifice are 2.6 m and 2.75 m respectively.
Find the discharge through totally drowned orifice of width 3.3 m if the difference of water levels on both side of the orifice be 50 cm. The height of water from to and bottom of the orifice are 2.25 m and 2.67 m respectively.