Bissoy.com
Doctors Medicines MCQs Q&A

The refrigerants which are first cooled by _________ refrigerants and then used for cooling purposes are known as ___________ refrigerants.

The refrigerants which are first cooled by _________ refrigerants and then used for cooling purposes are known as ___________ refrigerants. Correct Answer primary, secondary

Primary refrigerants are the one which takes a direct part in the refrigeration system. By absorbing the latent heat of vaporization effective refrigeration in produced. Whereas, refrigerants used for cooling purpose but firstly cooled by primary refrigerants are secondary refrigerants.

Related Questions

Consider the following statements for cooling towers: 1. Cooling tower is an artificial device used to cool the hot cooling water coming out of condenser more effectively. 2. The amount of water usually lost with induced draft cooling tower ranges from 5% to 6% by evaporation. 3. The amount of water usually lost with induced draft cooling tower ranges from 7% to 8% by drift losses. 4. The rate of evaporation of water and its cooling effect on the remaining water depends upon the relative humidity of air passing through the tower. Which of the above statements are correct?
Statement (I): Piston temperature profiles near full load are flattened in case of liquid cooled engines whereas for air cooled engines temperature profiles are steeper. Statement (II): The piston temperature profiles are different in nature for liquid cooled and air cooled engines because of the different values of heat capacities.
Concentrated fermentation liquid containing 20% (w/w) gluconic acid from an evaporator has a flow rate of 2000 kg/h and a temperature 90 °C. It needs to be cooled to 6 °C in a heat exchanger with cooling water. The cooling water has a flow rate 2700 kg/h and an initial temperature 2 °C. If the cooling water leaves the heat exchanger at 50 °C, what is the rate of heat loss from gluconic acid solution to the surroundings? Assume the heat capacity of gluconic acid is 0.35 cal/g-°C-1.
The bypass factor, in case of sensible cooling of air, is given by (where td₁ = Dry bulb temperature of air entering the cooling coil, td₂ = Dry bulb temperature of air leaving the cooling coil, and td₃ = Dry bulb temperature of the cooling coil)
The bypass factor, in case of sensible cooling of air, is given by (where td1 = Dry bulb temperature of air entering the cooling coil, td2 = Dry bulb temperature of air leaving the cooling coil and td3 = Dry bulb temperature of the cooling coil)
In liquid cooling, the liquid becomes heated in its passage through the jackets and is itself cooled by means of an air-cooled radiator system.
The control of cooling system in air-cooled system is not easier than in water-cooled system.
The lubricating oil for a large industrial gas turbine engine is cooled in a counter flow, concentric tube heat exchanger. The cooling water flows through the inner tube ( diameter = 25 mm) with inlet temperature 25 degree celsius and mass flow rate 0.2 kg/s. The oil flows through the annulus (diameter = 50 mm) with mass flow rate 0.125 kg/s and its temperature at entry and exit are 90 degree Celsius and 60 degree Celsius. Find outlet temperature of cooling water
Low-temperature cascade system use refrigerants with ______ boiling temperature and high temperature cascade system use refrigerants with _________ boiling temperature.
Consider the following statements in respect of natural-draft cooling towers: 1) Theoretically the water can be cooled to even below the dry-bulb temperature of the induced air flow. 2) Nature-draft cooling towers are 100 m or more in height. 3) The inner and outer surfaces are surfaces of revolution of a segment of a hyperbola about the vertical axis-affording improved strength rather than any thermodynamic augmentation. Which of the above statements are correct?