Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which of the following option is true for given statements regarding gauges for tapers? Statement 1: Use of double ended gauges is very important in limit gauges for tapers. Statement 2: Gauges should be packed in non-absorbent paper.
Which of the following option is correct for given statements about plug gauges for self-holding tapers? Statement 1: Plug is inserted with high pressure for checking taper. Statement 2: Morse taper is a type of self-holding taper.
During taper turning operation 100mm of smaller side diameter and 800mm of bigger side diameter was required. What will be the value of taper gradient for a job of 1m in length?
There are 150 gearwheels in a box, out of which 112 are within the required tolerance, 21 are below and rest are above the required tolerance. If the selection is done without replacement, the combined probability of randomly selecting a gearwheel below the tolerance and then a second one above the tolerance is
A resistor of 10 kΩ with 5% tolerance is connected in parallel with a 5 kΩ resistor of 10% tolerance. What is the tolerance limit for the parallel network?
Consider the following statements: 1. When a soil sample is dried beyond its shrinkage limit, the volume of the soil slowly decrease 2. The plastic limit is always lower than the liquid limit for any type of soil 3. At the liquid limit, the soil behaves like a liquid and possesses no shear strength at all 4. When subjected to drying, the volume of the soil remains unchanged once the water content of the soil goes below its shrinkage limit Which of the above statements are correct? 
What are the different limit states of design as per IS 456: 2000? a. Limit state of failure b. Limit state of damage c. Limit state of collapse d. Limit state of serviceability
The larger diameter of shaft is 125 mm and smaller diameter of the shaft is 95 mm. Find the taper. Assume that length of the job and taper is same.
Which of the following statements about vacuum gauges are correct? Statement 1: Thermal vacuum gauges sense the cooling effect of a heated filament. Statement 2: Thermal vacuum gauges designed to measure high pressures.
During taper turning operation 100mm of smaller side diameter and 800mm of bigger side diameter was required. What will be the value of Conicity for a job of 1m in length?