Related Questions

Sand Slinger is used for filling and ramming a large core.
A sand slinger works at a high speed.
Assertion A: Slow sand filters are more efficient in removal of bacteria than rapid sand filters.
Reason R: The sand used in slow sand filters is finer than that in rapid sand filters
Select your answer based on the coding system given below:
An electric motor drives a machine through a speed reducing gear of ratio 9:1. The motor armature, with its shaft and gear wheel, has moment of inertia 0.6 kg-m2. The rotating part of the driven machine has moment of inertia 45 kg-m2. The driven machine has resisting torque of 100 N-m and the efficiency of reduction gear is 95%. Find the power which the motor must develop to drive the machine at a uniform speed of 160 r.p.m.
A large tank of height h is half-filled with a liquid of density ρ and other half-filled with a liquid of density 4ρ. A similar tank is half-filled with a liquid of density 2ρ and other-half filled with another liquid of density 3ρ as shown. What will be the ratio of the instantaneous velocities of discharge through a small opening at the base of the tanks? (assume that the diameter of the opening is negligible compared to the height of the liquid column in either of the tanks)
Determine the density specific impulse (Id) if the specific impulse is 315 s and the average density of the propellants is 840 kg/m3. Take the reference density to be the maximum density of water.
Cleaning is done by
(i) Scraping and removal in filters slow sand
(ii) Back washing in slow sand filters
(iii) Scraping and removal in filters rapid sand
(iv) Back washing in rapid sand filters
The correct answer is
In sand moulding, the thickness of sand mould and bond strength should be high as much as possible to avoid sand inclusion in machine parts.
A machine P can print out one lakh books in 8 hours. Machine Q can print the same number of books in 10 hours while machine R can print them in 12 hours. All the machines are started at 9 A.M.While machine P is stopped at 11 A.M. and remaining two machines completed the work. Approximately at what at what time will the work time (to print one lakh books) be finished?
A small factory with 3 machines has a job of stamping out a number of pan covers. The newest machine can do the job is 3 days, another machine can do it in 4 days, and the third machine can do it in 6 days. How many days will the factory take to do the job using all the machine?