What is the maximum value of the addendum of the pinion?

What is the maximum value of the addendum of the pinion? Correct Answer mt((1+G(G+2)sin2 φ)0.5-1)/2

Since, aw max = mT((1+(1/G)((1/G)+2)sin2φ)0.5 – 1)/2 is the maximum value of addendum for the wheel, similarly, for pinion, the maximum value of addendum is given by mt((1+G(G+2)sin2 φ)0.5-1)/2. If the maximum value of addendum is less than the actual value of addendum, then interference occurs.
Bissoy MCQ

Related Questions

The angular velocity of the pinion is 75 rpm and that of the gear is 25 rpm. The addendum radius is 45 mm for the pinion and the radius of the pinion is 40 mm. The pressure angle between the gears is 25°. Find the velocity of sliding at the end of the contact.
Find the maximum value of addendum radius of the pinion if the pinion has 25 teeth, the larger gear has 100 teeth and the pressure angle is equal to 20°. Take the value of module as 6 mm.
The angular velocity of the pinion is 150 rpm and that of the gear is 75 rpm. The number of teeth on the pinion is equal to 20 and the module = 6 mm. The value of addendum is equal to 1 module. The pressure angle between the two gears is 20°. Find the velocity of sliding at the end of the contact.
A pair of parallel helical gears consist of 15 teeth pinion meshing with a 40 teeth gear. The helix angle is 22⁰ and normal pressure angle 19⁰. The normal module is taken as 4mm. Calculate addendum circle diameter of the pinion.
The velocity ratio between pinion and gear in a gear drive is 2.3, the module of teeth is 2.0 mm and sum of number of teeth on pinion and gear is 99. What is the centre distance between pinion and the gear?
If the maximum addendum radius of the wheel is given as 260 mm and the actual value of the addendum radius is found out to be 255 mm, the interference will occur. True or false?
Find the maximum value of addendum radius of the larger gear if the pressure angle between two teeth is equal to 25°. T = 50 and t = 25. The gears have a module of 8 mm and the addendum is equal to one module.
Find the maximum value of addendum radius of the larger gear if the pinion has 17 teeth, the larger gear has 51 teeth and the pressure angle is equal to 15°. Take the value of module as 8 mm.
Given, Involute profile teeths of mating gear: 20 and 40 Pressure angle = 20° module = 10mm The constraint: The addendum on each wheel is to be made of such a length that the line of contact on each side of the pitch point has half the maximum possible length. Find the addendum height for the larger gear wheel in mm.
Given: Involute profile teeths of mating gear: 20 and 40 Pressure angle = 20° module = 10mm The constraint: The addendum on each wheel is to be made of such a length that the line of contact on each side of the pitch point has half the maximum possible length. Find the addendum height for the smaller gear wheel in mm.