Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following is true for Length of arc of contact?

Which of the following is true for Length of arc of contact? Correct Answer Sum of Arc of recess and Arc of approach

The arc of contact is given by the sum of Length of arc of approach and length of arc of recess. Numerically it is the ratio of length of path of contact and the cosine of the pressure angle.

Related Questions

Four points L, M, N, and P are chosen on the circumference of a circle as shown in the figure given below. If 4 arc-length(LM) = 4 arc-length(NP) = 2 arc-length(MN) = πR , where ‘R’ is the radius of the circle, then what is the measure of the ∠MON ?
Consider the following statements: In case of helical gears, teeth are cut at an angle to the axis of rotation of the gears. 1) Helix angle introduces another ratio called axial contact ratio. 2) Transverse contact ratio is equal to axial contact ratio in helical gears. 3) Large transverse contact ratio does not allow multiple teeth to share the load. 4) Large axial contact ratio will cause larger axial force component Which of the above statements are correct?
Arrange the following stages in a sequence, such that they result in an ogee curve between two parallel lines AB and CD, such that they are the tangents to the arc. m) Join the adjacent ends B and C with a straight line. n) Divide the line BC into four parts using the points P1, P2, P3. o) Draw lines such that they pass through the points P1, P2, P3, and are perpendicular to the line BC. p) Draw the perpendicular lines through the points B and C such that they cut the lines passing through P1, P3 respectively at E and F. q) With the center E draw an arc BP2 and with center F draw an arc P2C, thus arc BP2C is required ogee curve.
If a gas metal arc process uses a low arc voltage and the arc is continuously interrupted as the molten electrode metal fills up the arc gap is known as
Given are the steps to draw a tangent to given arc even if center is unknown and the point P lies on it. Arrange the steps. Let AB be the arc. i. Draw EF, the bisector of the arc CD. It will pass through P. ii. RS is the required tangent. iii. With P as center and any radius draw arcs cutting arc AB at C and D. iv. Draw a perpendicular RS to EF through P.
A circular arc QTS is kept in an external magnetic field $${\overrightarrow {\bf{B}} _0}$$ as shown in figure. The arc carries a current $$l$$. The magnetic field is directed normal and into the page. The force acting on the arc is
Electromagnetic Theory mcq question image
Given: Involute profile teeths of mating gear: 20 and 40 Pressure angle = 20° module = 10mm The constraint: The addendum on each wheel is to be made of such a length that the line of contact on each side of the pitch point has half the maximum possible length. Find the length of arc of contact in mm.
Consider a circle of radius 4 cm such that  A1, A2, A3, A4, A5, A6 are 6 points in the given order on the circle. The length of the arc AxAx + 1 is 1/3 times the length of the arc Ax + 1Ax + 2. If the circumference of the circle is 6 times the sum of the lengths of the 5 arcs then what is the angle subtended by the arc A2A3 at the center of the circle? 
If angle of arc is 60° and the length of arc is 20 cm. Find the radius of the circle from which arc is intercepted.
If length of arc is 40 cm and radius of circle of arc is 10 cm then find the angle made by the arc.