Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statements: 1. In spur gears, the contact occurs abruptly on a line parallel to the axis, and the disengagement too is abrupt. 2. In helical gears, both loading and unloading are gradual, and therefore, these happen more smoothly and less noisily 3. When two gears mesh, any arbitrary shape of the tooth can be chosen for the profile of the teeth of any one of the two gears, and the profile for the other shall be obtained by applying the law of gearing. Which of the above statements are correct?
Consider the following statements: In case of helical gears, teeth are cut at an angle to the axis of rotation of the gears. 1) Helix angle introduces another ratio called axial contact ratio. 2) Transverse contact ratio is equal to axial contact ratio in helical gears. 3) Large transverse contact ratio does not allow multiple teeth to share the load. 4) Large axial contact ratio will cause larger axial force component Which of the above statements are correct?
Which of the following statements are correct for mating gears with involute profiles? 1. The pressure angle, from the start of the engagement to the end of the engagement, remains constant. 2. The pressure angle is maximum at the beginning of the engagement, reduces to zero at pitch point, starts decreasing and again becomes maximum at the end of the engagement. 3. The face and flank of the teeth are generated by a single curve and the normal to this curve at any point is tangent to the base circle of the gear. 4. The centre distance for a pair of mating gears can be varied within limits without altering the velocity ratio. Select the correct answer using the code given below.
Which of the following statements are correct for mating gears with involute profiles? (i) The pressure angle, from the start of the engagement to the end of the engagement, remains constant. (ii) The pressure angle is maximum at the beginning of the engagement, reduces to zero at pitch point, starts decreasing and again becomes maximum at the end of the engagement. (iii) The face and flank of the teeth are generated by a single curve and the normal to this curve at any point is tangent to the base circle of the gear. (iv) The centre distance for a pair of mating gears can be varied within limits without altering the velocity ratio. Select the correct answer using the code given below.
When bevel gears connect two shafts whose axes intersect at an angle greater than a right angle and one of the bevel gears has a pitch angle of 90°, then they are known as
The pressure angle of two gears in a mesh is φ = 22.5°. The number of teeth on the pinion is 25 and the gear ratio is 2. The module is 7 mm and addendum = 1 module. Find the angle of action of these two gears.
Angle ‘A’ of a cyclic quadrilateral ABCD is 53° less then angle B. Angle B is twice of angle C and angle C is 40° more than angle D. What would be the measure of angle A?
A pair of parallel helical gears consist of 15 teeth pinion meshing with a 40 teeth gear. The helix angle is 22⁰ and normal pressure angle 19⁰. The normal module is taken as 4mm. Calculate the transverse pressure angle in degrees.
Among the following types of gears, which gears offer a refinement over spur gears?
Statement (I): Two  non-intersecting and non-parallel, i.e., non-coplanar, shafts connected by gears are called skew-bevel gears or spiral gears, and this type of gearing has a line contact the rotation of which about the axes generates the two hyperboloid pitch surfaces. Statement (II): A hyperboloid is a 3D surface formed by revolving a straight line about an axis (not in the same plane), such that every point on the line remains at a constant distance from the axis.