Bissoy.com
Doctors Medicines MCQs Q&A

Pressure angle of involute gears does not exceed 250, since

Pressure angle of involute gears does not exceed 250, since Correct Answer this will lead to unwanted radial force

Pressure angle of involute gears does not exceed 250, since Gear is curved.

Related Questions

Which of the following statements are correct for mating gears with involute profiles? 1. The pressure angle, from the start of the engagement to the end of the engagement, remains constant. 2. The pressure angle is maximum at the beginning of the engagement, reduces to zero at pitch point, starts decreasing and again becomes maximum at the end of the engagement. 3. The face and flank of the teeth are generated by a single curve and the normal to this curve at any point is tangent to the base circle of the gear. 4. The centre distance for a pair of mating gears can be varied within limits without altering the velocity ratio. Select the correct answer using the code given below.
Which of the following statements are correct for mating gears with involute profiles? (i) The pressure angle, from the start of the engagement to the end of the engagement, remains constant. (ii) The pressure angle is maximum at the beginning of the engagement, reduces to zero at pitch point, starts decreasing and again becomes maximum at the end of the engagement. (iii) The face and flank of the teeth are generated by a single curve and the normal to this curve at any point is tangent to the base circle of the gear. (iv) The centre distance for a pair of mating gears can be varied within limits without altering the velocity ratio. Select the correct answer using the code given below.
Consider the following statements: In case of helical gears, teeth are cut at an angle to the axis of rotation of the gears. 1) Helix angle introduces another ratio called axial contact ratio. 2) Transverse contact ratio is equal to axial contact ratio in helical gears. 3) Large transverse contact ratio does not allow multiple teeth to share the load. 4) Large axial contact ratio will cause larger axial force component Which of the above statements are correct?
Consider the following statements: In the case of involute gears in contact 1. the motion is one of pure rolling 2. pressure angle does not change during contact 3. velocity ratio does not change 4. output torque of the driven gear changes Which of the above statements are correct?
Consider the following statements: 1. In spur gears, the contact occurs abruptly on a line parallel to the axis, and the disengagement too is abrupt. 2. In helical gears, both loading and unloading are gradual, and therefore, these happen more smoothly and less noisily 3. When two gears mesh, any arbitrary shape of the tooth can be chosen for the profile of the teeth of any one of the two gears, and the profile for the other shall be obtained by applying the law of gearing. Which of the above statements are correct?
Consider the following statements regarding capability curves of a synchronous generator: 1. The MVA loading should not exceed the generator rating. 2. The field current should not be allowed to exceed a specified value determined by field heating. 3. The MW loading should not exceed the rating of the prime mover. 4. The load angle must be more than 90°. Which of the above statements are correct?
When bevel gears connect two shafts whose axes intersect at an angle greater than a right angle and one of the bevel gears has a pitch angle of 90°, then they are known as
Involute gears have greater contact area as compared to cycloidal gears.
Gears having teeth cut on the rotating face plane of the gear and mate with standard involute spur gears are known as
The pressure angle of two gears in a mesh is φ = 22.5°. The number of teeth on the pinion is 25 and the gear ratio is 2. The module is 7 mm and addendum = 1 module. Find the angle of action of these two gears.