Length Of Arc of Contact MCQ

Test your knowledge with important Length Of Arc of Contact MCQ and their applications. These MCQs are beneficial for competitive exams too. Explore 30 + more Length Of Arc of Contact MCQs at Bissoy

• An epicyclic gear train has 3 shafts A,B and C. A is an input shaft running at 100 r.p.m. clockwise. B is an output shaft running at 250 r.p.m. clockwise. Torque on a is 50 kNm. C is a fixed shaft. The torque to fix C
  ক

  is 20 kNm anticlockwise

  খ

  is 30 kNm anticlockwise

  গ

  is 30 kNm clockwise

  ঘ

  cannot be determined as the data is insufficient
• In a simple gear train, if the number of idler gears is odd, then the direction of motion of driven gear will
  ক

  be same as that of the driving gear

  খ

  be opposite to that of the driving gear

  গ

  depend upon the number of teeth on the driving gear

  ঘ

  depend upon the total number of teeth on all gears of the train
• The velocity ratio in the case of the compound train of wheels is equal to
  ক

  No. of teeth on first driver/No.of teeth on last follower

  খ

  No. of teeth on last follower/No.of teeth on first driver

  গ

  Product of teeth on the drivers/Product of teeth on the followers

  ঘ

  Product of teeth on the followers/Product of teeth on the drivers
• Which of the following statements are correct for mating gears with involute profiles? (i) The pressure angle, from the start of the engagement to the end of the engagement, remains constant. (ii) The pressure angle is maximum at the beginning of the engagement, reduces to zero at pitch point, starts decreasing and again becomes maximum at the end of the engagement. (iii) The face and flank of the teeth are generated by a single curve and the normal to this curve at any point is tangent to the base circle of the gear. (iv) The centre distance for a pair of mating gears can be varied within limits without altering the velocity ratio. Select the correct answer using the code given below.
  ক

  1, 3 and 4

  খ

  1 and 3 only

  গ

  2 and 4 only

  ঘ

  2,3 and 4
• Two involute gears are designed to mesh for a given centre distance and a given angular velocity ratio (other than 1). During assembly, the centre distance has increased slightly. Then which of the following changes occur? (i) Velocity ratio changes (ii) Pressure angle changes (iii) Pitch circle diameter changes (iv) Working depth changes (v) Base circle radius changes Select the correct answer using the code given below.
  ক

  1, 2 and 3

  খ

  2, 3 and 4

  গ

  2 and 5

  ঘ

  3 and 5
• Worm and worm wheel drive can be reversible.
  ক

  True

  খ

  False
• Pressure angle of involute gears does not exceed 250, since
  ক

  this will lead to unwanted radial force

  খ

  the number of teeth to avoid undercutting will be very high

  গ

  no cutters are available

  ঘ

  gear will become too small
• If the centre distance between a pair of spur gears in mesh is 240 mm and the pinion moves five times faster than the gear, then the pitch circle diameters of pinion and gear respectively are
  ক

  40mm and 200 mm

  খ

  80mm and 400 mm

  গ

  60mm and 300 mm

  ঘ

  50mm and 250 mm