Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Two 20° involute spur gears have a module of 12 mm. The addendum is equal to 1.5 module. If the larger gear has 40 teeth and the pinion has 20 teeth, find the pressure angle at which interference can be avoided.
Which of the following statements are correct for mating gears with involute profiles? 1. The pressure angle, from the start of the engagement to the end of the engagement, remains constant. 2. The pressure angle is maximum at the beginning of the engagement, reduces to zero at pitch point, starts decreasing and again becomes maximum at the end of the engagement. 3. The face and flank of the teeth are generated by a single curve and the normal to this curve at any point is tangent to the base circle of the gear. 4. The centre distance for a pair of mating gears can be varied within limits without altering the velocity ratio. Select the correct answer using the code given below.
Which of the following statements are correct for mating gears with involute profiles? (i) The pressure angle, from the start of the engagement to the end of the engagement, remains constant. (ii) The pressure angle is maximum at the beginning of the engagement, reduces to zero at pitch point, starts decreasing and again becomes maximum at the end of the engagement. (iii) The face and flank of the teeth are generated by a single curve and the normal to this curve at any point is tangent to the base circle of the gear. (iv) The centre distance for a pair of mating gears can be varied within limits without altering the velocity ratio. Select the correct answer using the code given below.
Consider the following modifications regarding avoiding the interference between gears: 1. The centre distance between meshing gears be increased 2. Addendum of the gear be modified 3. Teeth should be undercut slightly at the root 4. Pressure angle should be increased 5. Circular pitch be increased Which of these are effective in avoiding interference?
Two involute gears have a pressure angle of 20°. The gear ratio is given to be 3. The module is 5 mm and the value of addendum is equal to 1 module. Determine the minimum number of teeth on each wheel to avoid interference, if the pinion rotates at 100 rpm.
Consider the following statements: 1. In spur gears, the contact occurs abruptly on a line parallel to the axis, and the disengagement too is abrupt. 2. In helical gears, both loading and unloading are gradual, and therefore, these happen more smoothly and less noisily 3. When two gears mesh, any arbitrary shape of the tooth can be chosen for the profile of the teeth of any one of the two gears, and the profile for the other shall be obtained by applying the law of gearing. Which of the above statements are correct?
Interference in a pair of gears is avoided, if the addendum circles of both the gears intersect common tangent to the base circles within the points of tangency.
The interference between a given pinion tooth and a gear tooth can be avoided by using 1. smaller pressure angle 2. larger pressure angle 3. Less number of teeth on the gear for a pinion with predefined number of teeth 4. More number of teeth on the gear for a pinion with predefined number of teeth Which of the above statements are correct?
Consider the following statements: In case of helical gears, teeth are cut at an angle to the axis of rotation of the gears. 1) Helix angle introduces another ratio called axial contact ratio. 2) Transverse contact ratio is equal to axial contact ratio in helical gears. 3) Large transverse contact ratio does not allow multiple teeth to share the load. 4) Large axial contact ratio will cause larger axial force component Which of the above statements are correct?
The problem of interference in an involute pinion, which has to come in external mesh with a gear, can be avoided by