Bissoy.com
Doctors Medicines MCQs Q&A

What is the unit of constant of proportionality C used in the relation between displacement of slider and crank angle?

What is the unit of constant of proportionality C used in the relation between displacement of slider and crank angle? Correct Answer m/rad

The displacement of the slider is proportional to the crank angle hence a proportionality constant C is introduced; this has the units metre/radians. m/rad.

Related Questions

Consider the following statements: In a slider-crank mechanism, the slider is at its dead centre position when the (i) slider velocity is zero (ii) slider velocity is maximum (iii) slider acceleration is zero (iv) slider acceleration is maximum Which of the above statements are correct?
If the crank rotation angle varies from 45 degrees to 135 degrees, Using three precision points with chebyshev’s spacing, synthesize a slider crank mechanism where where displacement of slider is square of the crank rotation. From the above information calculate ‘a’ in mm.
If the crank rotation angle varies from 45 degrees to 135 degrees, Using three precision points with chebyshev’s spacing, synthesize a slider crank mechanism where where displacement of slider is square of the crank rotation. From the above information calculate ‘c’ in mm.
If the crank rotation angle varies from 45 degrees to 135 degrees, Using three precision points with chebyshev’s spacing, synthesize a slider crank mechanism where where displacement of slider is square of the crank rotation. From the above information calculate ‘b’ in mm.
In a slider crank mechanism, the length of the crank and connecting rod are 150 mm and 600 mm respectively. The crank position is 60° from inner dead centre. The crank shaft speed is 400 r.p.m. (clockwise). Velocity of the slider is ________
In a slider crank mechanism, the crank rotates with a constant angular velocity of 300 rpm, Length of crank is 150mm, and the length of the connecting rod is 600mm. Determine linear velocity of the midpoint of the connecting rod in m/s. Crank angle = 45° from IDC.
In a slider crank mechanism, the crank rotates with a constant angular velocity of 300 rpm, Length of crank is 150mm, and the length of the connecting rod is 600mm. Determine acceleration of the midpoint of the connecting rod in m/s2. Crank angle = 45° from IDC.
Match list I with list II List I List II A. Pantograph 1. Scotch yoke mechanism B. Single slider crank 2. Double lever mechanism C. Double slider crank chain 3. Tchebicheff’s mechanism D. Straight line motion mechanism 4. Double crank 5. Hand pump
In a slider crank mechanism, the length of the crank and connecting rod are 180 mm and 540 mm respectively. The crank position is 45° from inner dead centre. The crank shaft speed is 450 r.p.m. (clockwise), calculate angular velocity of the connecting rod in rad/s.
In a slider-crank mechanism, the crank is rotating with an angular velocity of 20 rad/s in counterclockwise direction. At the instant when the crank is perpendicular to the direction of the piston movement, velocity of the piston is 2 m/s. Radius of the crank is