Bissoy.com
Doctors Medicines MCQs Q&A

The ratio of the maximum displacement of the forced vibration to the deflection due to the static force, is known as

The ratio of the maximum displacement of the forced vibration to the deflection due to the static force, is known as Correct Answer magnification factor

Magnificiant Factor is the ratio of maximum displacement of the forced vibration (xmax) to the deflection due to the static force F(xo). Damping Factor is the ratio of amping coefficient for the actual system, and damping coefficient for the critical damped system.

Related Questions

Statement: Resonance is a special case of forced vibration in which the nature and frequency of vibration of the body are the same as the impressed frequency and the amplitude of forced vibration, is maximum. Reason: The amplitude of forced vibrations of a body increases with an increase in the frequency of the externally impressed periodic force.
Maximum displacement due to forced vibration is dependent on deflection due to static force.
Which of the following are the basic differences between vibration signature and noise signature? 1. Vibration signature is essentially in the frequency range zero to 100 cps whereas noise signature is in the range 20 cps to 3000 cps. 2. Vibration signature has well-defined peaks whereas the noise signal is smeared. 3. The intensities of noise signatures arc much less than that of vibration signatures. 4. Detection of vibration signature calls for a microphone whereas that of noise can do with a pickup. Select the correct answer using the code given below.
Study the following statements.i) The displacement method is more useful when degree of kinematic indeterminacy is greater than the degree of static indeterminacy.ii) The displacement method is more useful when degree of kinematic indeterminacy is less than the degree of static indeterminacy.iii) The force method is more useful when degree of static indeterminacy is greater than the degree of kinematic indeterminacy.iv) The force method is more useful when degree of static indeterminacy is less than the degree of kinematic indeterminacy.The correct answer is
Consider the following statements in connection with deflection-type and null-type instruments: 1. Null-type instruments are more accurate than the deflection-type ones. 2. Null-type of instrument can be highly sensitive compared to a deflection-type instrument. 3. Under dynamic conditions, null-type instruments are less preferred to deflection-type instruments. 4. Response is faster in null-type instruments as compared to deflection-type instruments. Which of the above statements are correct?
Which of the following statements regarding static methods are correct?
1. Static methods are difficult to maintain, because you can not change their implementation.
2. Static methods can be called using an object reference to an object of the class in which this method is defined.
3. Static methods are always public, because they are defined at class-level.
4. Static methods do not have direct access to non-static methods which are defined inside the same class.
In a system subjected to damped forced vibrations, the ratio of maximum displacement to the static deflection is known as
Magnification factor is the ratio of the maximum displacement due to forced vibrations to the deflection due to _______
A displacement sensor (a dial indicator) measures the lateral displacement of a mandrel mounted on the taper hole inside a drill spindle. The mandrel axis is an extension of the drill spindle taper hole axis and the protruding portion of the mandrel surface is perfectly cylindrical measurements are taken with the sensor placed at two positions P and Q as shown in the figure. The readings are recorded as Rx = maximum deflection minus minimum deflection, corresponding to sensor position at X, over one rotation. If RP = RQ > 0, which one of the following would be consistent with the observation?
Consider the following statements for deflection and null type instruments: 1. Deflection type of instruments are more accurate than null type of instruments. 2. Deflection type of instruments can be highly sensitive as compared with the null type of instruments. 3. Null type of instruments are more suitable for measurements under dynamic conditions than deflection type of instruments. Which of the above statements are not correct?