Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following is a function of a belt transmission dynamometer?

Which of the following is a function of a belt transmission dynamometer? Correct Answer Measure the difference in tension of the belts

The tangential force on the pulley which is driven is equal to the difference between the tensions in the tight and slack sides of the belt. A belt dynamometer is inserted to measure directly the difference between the tensions of the belt.

Related Questions

Belt transmission dynamometer is a transmission dynamometer.
Consider the following statements regarding V-belt drive : 1. The groove angle of the sleeve is less than the belt section angle 2. The efficiency of a V-belt drive is higher than that of a flat belt drive 3. The groove angle is so made that the belt gets wedged in the groove  Which of the above statements are correct ? 
Belt transmission dynamometer is an absorption dynamometer.
Which of the following belts are associated with seismic activity?
1. Circum-Pacific Belt
2. Circum-Atlantic Belt
3. Mid-Continental Belt
4. Mid-Atlantic Belt
When the belt is transmitting maximum power, the belt speed should be (Where, m = mass of belt per meter (kg/m) and Pmax = maximum permissible tension in belt (N))
The efficiency of flat belt drive is 35%. If all the parameters are same and flat belt is replaced by V belt, than the efficiency of V belt will be?
When the belt is transmitting maximum power, the belt speed should be
(Where, m = mass of belt per meter (kg/m) and Pmax = maximum permissible tension in belt (N))
A bucket wheel excavator with 20 buckets of capacity 0.5 m3 each, rotates at 5 rev/min. The bucket fill factor is 80%. The excavator loads on to 1200 mm wide belt conveyor. The cross-section area (m2) of the material on the belt is 0.1B2, where B is the belt width in m. The minimum speed of the belt in m/s to avoid spillage of material is
The ratio of belt tensions $$\frac{{{{\text{p}}_1}}}{{{{\text{p}}_2}}}$$ considering centrifugal force in flat belt is given by where,
m = mass of belt per meter (kg/m)
v = belt velocity (m/s)
f = coefficient of friction
$$\alpha $$ = angle of wrap (radians)
Bevis-Gibson Flash Light Torsion Dynamometer is a transmission dynamometer.