Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which are the correct statements? (a) Film condensation usually occur on oily surface. (b) Temperature of condensate gradually increases towards the liquid-vapour interface. (c) Suitable coating is used to promote dropwise condensation. (d) Dropwise condensation gives lower heat transfer rate than film condensation.
Consider the following statements (i) If a condensing liquid does not wet a surface, then drop wise condensation will not take place on it (ii) Drop wise condensation gives a higher transfer rate than film wise condensation (iii) Reynolds number of condensing liquid is based on its mass flow rate (iv) Suitable coating or vapor additive is used to promote film wise condensation Identify the correct statement
Statement 1: Film-type condensation has a higher heat transfer co-efficient than drop-wise condensation. Statement 2: Drop-wise condensation is easier to maintain than Film-type condensation
Statement 1: For non-Newtonian fluids, another term called apparent viscosity is used as their viscosity changes with the change in the shear rate. Statement 2: For non-Newtonian fluids, between the transition region, the power number for non-Newtonian fluids is slightly higher than that for Newtonian fluids.
Consider the following statements regarding nucleate boiling (i) The temperature of the surface is greater than the saturation temperature of the liquid (ii) Bubbles are created by the expansion of entrapped gas oil vapor at small cavities in the surface (iii) The temperature is greater than that in film boiling (iv) The heat transfer from the surface to the liquid is greater than that in the film boiling Which of these statements are correct?
Group I shows different heat addition processes in power cycles. Likewise, Group II shows different heat removal processes. Group III lists power cycles. Match items from Groups I, II and III. Group I Group II Group III P. Pressure constant S. Pressure constant 1. Rankine cycle Q. Volume constant T. Volume constant 2. Otto cycle R. Temperature constant U. Temperature constant 3. Carnot cycle     4. Diesel cycle     5. Brayton cycle
Consider the following statements: 1. The relative humidity of air does not change with temperature as long as specific humidity remains constant. 2. Dew-point temperature is the temperature at which condensation begins when air is cooled at constant volume. 3. Saturated air passing over a water surface does not cause change of air temperature. 4. For saturated air, dry-bulb, wet-bulb and dew-point temperatures are identical. Which of the above statements are correct?
Match List-I with List-II and select the correct answer using the code given below the Lists: List I (Low-Latitude Climate) List I (Characteristic) A. Wet Equatorial 1. Uniform temperatures, mean near 27°C  B. Monsoon and trade wind coastal 2. Marked temperature cycle with very high temperature before the rainy season C. Wet-dry tropical  3. Temperatures show an annual cycle with a high temperature in the high-Sun season Strong temperature cycle. with intense temperature during the high-Sun season  D. Dry tropical 4. Strong temperature cycle, with intense temperature during the high-Sun season
Low-temperature cascade system use refrigerants with ______ boiling temperature and high temperature cascade system use refrigerants with _________ boiling temperature.
Consider the following statements for the appropriate context: 1. The Relative Humidity of air remains constant during sensible heating or cooling 2. The Dew Point Temperature of air remains constant during sensible heating or cooling 3. The total enthalpy of air remains constant during adiabatic cooling 4. It is necessary to cool the air below its Dew Point Temperature for dehumidifying Which of the above statements are correct?