Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

A fillet-welded joint is subjected to transverse loading F as shown in the figure. Both legs of the fillets are of 10 mm size and the weld length is 30 mm. If the allowable shear stress of the weld is 94 MPa, considering the minimum throat area of the weld, the maximum allowable transverse load per weld in kN is
Parallel fillet weld and transverse fillet weld both have the plane in which maximum shear stress occurs at 45’ to the leg dimension.
Strength of parallel fillet weld is greater than strength of transverse fillet weld.
The permissible stress in the fillet weld is 100 N/mm². The fillet weld has equal leg lengths of 15 mm each. The allowable shearing load on the weldment per cm length of the weld is
A single transverse weld is preferred over double transverse fillet weld.
A double fillet welded joint with parallel fillet weld of length '$$l$$' and leg 's' is subjected to a tensile force 'P'. Assuming uniform stress distribution, the shear stress in the weld is given by
With reference to the following figure, a plate, 75mm wide and 10mm thick, is joined with another plate as shown. The permissible tensile and shear stress in the welds are 50/mm² and 40N/mm². Determine the required length of each parallel fillet weld if length of transverse weld is 40mm.
Which of the following statements are correct in respect of welded connections? 1) Strength of Butt weld is equal to the strength of components joined. 2) Fillet welds carry the loads computed based on the tensile strength characteristics of fusion material. 3. for effective transmission of load by fillet weld, the fusion faces shall subtend an angle between 60° and 120° 
In a transverse fillet welded joint, the size of weld is __________ the throat of weld.
A force 2P is acting on the double transverse fillet weld. Leg of weld is h and length l. Determine the shear stress in a plane inclined at θ with horizontal.