Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statements in connection with thrust bearings: 1) Cylindrical thrust bearings have higher coefficient of friction than ball thrust bearings. 2) Taper rollers cannot be employed for thrust bearings. 3) Double-row thrust ball bearing is not possible 4) Lower race, outer race and retainer are readily separable in thrust bearings. Which of the above statements are correct?
Five friends went for a trip where each carried a certain number of apples with them. The number of apples carried by C was 1 less than that by D, which was 5 more than the number of apples carried by E. The total number of apples carried by A and B both was equal to the average number of apples carried by C, D and E. If D carried more apples than B and they together carried 14 apples, which of the following is a possible value of the apples carried by A?
The bearing is subjected to a radial load of 4000N. Expected life for 90% bearings is 9000h and shaft is rotating at 1500rpm. Calculate the dynamic load capacity.
A rotor which is balanced statically but not dynamically is supported on two bearings L apart and at high speed of the rotor, reaction on the left bearing is R. The right side of the bearing is shifted to a new position 2L apart from the left bearing. At the same rotor speed, dynamic reaction on the left bearing in the new arrangement will
Consider the following two statements regarding Bearing stiffeners provided at the location of a concentrated load: 1. Bearing stiffeners have to resist bearing and buckling loads. 2. Bearing area and the area resisting buckling load are the same. Which of the above statements is/are correct ?
The product structure of an assembly P is shown in the figure. Estimated demand for end product P is as follows Week 1 2 3 4 5 6 Demand 1000 1000 1000 1000 1200 1200 ignore lead times for assembly and sub-assembly. Production capacity (per week) for component R is the bottleneck operation. Starting with zero inventory, the smallest capacity that will ensure a feasible production plan up to week 6 is
Consider that modern machines mostly use short bearings due the following reasons: 1) l/d of the most modern bearings is in the range of 1.4 to 2 2) No end leakage of oil from the bearing 3) Shaft deflection and misalignment do not affect the operation 4) Can be applied to both hydro-dynamic and hydrostatic cases Which of the above are correct?
Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?
Slot fill type ball bearings have higher load bearing capacity than Conrad type ball bearing.
Load-bearing walls are defined as those walls which carry their own weight only whereas non-load bearing walls are defined as those walls which can carry superimposed loads in addition to their own weight.