Bissoy.com
Doctors Medicines MCQs Q&A

The bracket welded to the vertical plate by means of two fillet welds. Calculate the bending stress in the welds if P=40kN, leg=4mm and e=400mm.

The bracket welded to the vertical plate by means of two fillet welds. Calculate the bending stress in the welds if P=40kN, leg=4mm and e=400mm. Correct Answer 34N/mm²

σ=My/I where y=250mm,I=2xtx500ᵌ/12 where t=4/.707.

Related Questions

The bracket welded to the vertical plate by means of two fillet welds. Calculate size of the welds if P=40kN, leg=4mm and e=400mm. Maximum permissible value of shear stress in the weld is 70N/mm².
A bracket is shown welded to a vertical column by means of two fillet welds. The bending stress induced in the welds can be given by
Which of the following statements are correct in respect of welded connections? 1) Strength of Butt weld is equal to the strength of components joined. 2) Fillet welds carry the loads computed based on the tensile strength characteristics of fusion material. 3. for effective transmission of load by fillet weld, the fusion faces shall subtend an angle between 60° and 120° 
A double fillet welded joint with parallel fillet weld of length '$$l$$' and leg 's' is subjected to a tensile force 'P'. Assuming uniform stress distribution, the shear stress in the weld is given by
With reference to the following figure, a plate, 75mm wide and 10mm thick, is joined with another plate as shown. The permissible tensile and shear stress in the welds are 50/mm² and 40N/mm². Determine the required length of each parallel fillet weld if length of transverse weld is 40mm.
The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm. If bending moment on point B in horizontal plate is M and in vertical plane is m, then the net bending moment at point B is?
If a circular shaft is welded to the plate by means of circumferential fillet, then the shaft is subjected to torsional moment M. If throat of weld is t, then torsional shear stress is given by
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
In Sanjay Cafe, the charges for Maharashtrian meal plate is Rs. 45 and charges for South Indian meal plate is Rs. 60. In a particular month, 40 Maharashtrian meal plate were served while number of South Indian meal plate served was 65, then what is the ratio of total charges collected for Maharashtrian meal plate and total charges collected for South Indian meal plate?
Rinki has three plates of Jalebies: Plate A, Plate B and Plate C. Plate A has only one Jalebi, Plate B has five Jalebies and Plate C has three Jalebies. She wants to put equal numbers of Jalebies in all the plates. Which of the following statement is true?