Bissoy.com
Doctors Medicines MCQs Q&A

In electron beam machining, the plane of _____ is on the surface of the workpiece.

In electron beam machining, the plane of _____ is on the surface of the workpiece. Correct Answer focusing

The plane of focusing would be on the surface of the workpiece or just below the surface of the workpiece. This controls the kerf shape or the shape of the hole.

Related Questions

Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
Consider the following statements with regards to the shear force diagram for the beam ABCD: 1. The beam ABCD is an overhanging beam having supports at A and D only. 2. The beam carries a point load of 20 kN at C. 3. The beam carries a concentrated load of 10 kN at the end B. 4. The beam is an overhanging beam having supports at C and D only. 5. The beam carries a uniformly distributed load of 70 kN over the left hand portion AC only. Which of the above statements are correct?
Consider the following statements regarding types of supports and beams: 1. When both supports of beams are roller supports, the beam is known as simply supported beam. 2. A beam with one end fixed and the other end free is known as fixed beam. 3. A beam with both ends fixed is known as cantilever beam. 4. A beam with one end fixed and the other simply supported is known as propped cantilever. Which of the above statements is/are correct ?
In which of the following cases, there exists the situation of Pure Bending in some part of the beam or along the entire beam? i) A simply supported beam subjected to two equally spaced downward concentrated loads ii) A simply supported beam subjected to two equally spaced opposite moments iii) A cantilever beam subjected to clockwise moment at free end iv) An overhanging beam with both side overhangs subjected to different concentrated loads at both the free ends
Which of the following are the properties of an electron? 1) Electron is a constituent of cathode ray 2) Electron is a negatively charged particle 3) The mass of the electron is equal to the mass of the proton 4) Electron is deflected by the electric field but not by magnetic field Select the correct answer using the code given below:
Which of the following machine is based upon the principle that the rotating edge of the tool exerts a large force on the workpiece and holes are being created in the workpiece? The material is removed from the workpiece by the shearing and extrusion process.
For the electron beam machining process, pulse duration for the electron beam is in range of_____
This are the following statements given regarding satellite’s motion a. A satellite in geostationary orbit lies in the same plane with equator b. A satellite in geosynchronous orbit lies in the same plane with equator c. A satellite in geostationary orbit does not lie in the same plane with equator, it is inclined at some angle from plane of equator d. A satellite in geosynchronous orbit does not lie in the same plane with equator, it is inclined at some angle from plane of equator Choose one of the following options
A line of 12 cm length is perpendicular to profile plane and the least distance from this line to profile plane is 6 cm. This is at a distance of 4 cm from the vertical plane and 5 cm from the horizontal plane. What is distance from the point on line far away from the profile plane to profile plane?
Find the velocity of an electron when its kinetic energy is equal to one electron volt (in 105m/s). Given charge of an electron e = 1.6 x 10-19 and mass of an electron m = 9.1 x 10-31.