Bissoy.com
Doctors Medicines MCQs Q&A

Compound rest swiveling method in taper turning operation is most suitable for

Compound rest swiveling method in taper turning operation is most suitable for Correct Answer Short jobs with steep taper angles

Compound rest swiveling method gives less space and less revolution and hence in taper turning operation it is most suitable for Short jobs with steep taper angles.

Related Questions

A set of jobs A, B, C, D, E, F, G, H arrive at time t = 0 for processing on turning and grinding machines. Each job needs to be processed in sequence - first on the turning machine and second on the grinding machine, and the grinding must occur immediately after turning. The processing times of the jobs are given below. Job A B C D E F G H Turning (minutes) 2 4 8 9 7 6 5 10  Grinding (minutes)  6 1 3 7 9 5 2 4 If the makespan is to be minimized, then the optimal sequence in which these jobs must be processed on the turning and grinding machines is
A cast iron piece of total length 100mm is needed to be tapered for a length of 40mm using swiveling the compound rest method. Diameter of job is 20mm and smaller end have nearly zero diameter. What should the angle in degrees by which compound rest should be rotated?
During taper turning operation 100mm of smaller side diameter and 800mm of bigger side diameter was required. What will be the value of taper gradient for a job of 1m in length?
In compound rest method, the amount of taper for setting the angle is calculated from this formula, tan of angle of taper =_____
Which of the following option is correct for given statements about plug gauges for self-holding tapers? Statement 1: Plug is inserted with high pressure for checking taper. Statement 2: Morse taper is a type of self-holding taper.
In compound slide method, one part of compound rest is swiveled to_____ the included angle of the taper.
For turning small taper on long workpiece, the suitable method is
For turning a small taper on a long workpiece, the suitable method is
In which of the following, tail stock method of taper turning operation will be preferred more?
During level turning operation my aircraft has load factor of 2. Find the required bank angle for this level turning operation.