Bissoy.com
Doctors Medicines MCQs Q&A

In which of the following, tail stock method of taper turning operation will be preferred more?

In which of the following, tail stock method of taper turning operation will be preferred more? Correct Answer Long slender tapers

For long slender tapers, tail stock over method is most suitable because tail stock method gives large space and large taper angle also.

Related Questions

An aircraft with wing aft tail configuration has tail efficiency of 0.95 and tail volume ratio of horizontal tail is 0.7. Determine pitching moment coefficient slope for the tail. Given lift curve slope of tail is 4.2 per rad. Consider downwash derivative as 0.6.
The tail stock set over method of taper turning is preferred for
A set of jobs A, B, C, D, E, F, G, H arrive at time t = 0 for processing on turning and grinding machines. Each job needs to be processed in sequence - first on the turning machine and second on the grinding machine, and the grinding must occur immediately after turning. The processing times of the jobs are given below. Job A B C D E F G H Turning (minutes) 2 4 8 9 7 6 5 10  Grinding (minutes)  6 1 3 7 9 5 2 4 If the makespan is to be minimized, then the optimal sequence in which these jobs must be processed on the turning and grinding machines is
A typical jet transport aircraft needs to be sized based on following parameters. Wing area S=50m2, MAC=5m. If tail volume coefficient of horizontal tail is 1 and tail area is 10m2 then, find the required tail moment arm.
During taper turning operation 100mm of smaller side diameter and 800mm of bigger side diameter was required. What will be the value of taper gradient for a job of 1m in length?
Which of the following option is correct for given statements about plug gauges for self-holding tapers? Statement 1: Plug is inserted with high pressure for checking taper. Statement 2: Morse taper is a type of self-holding taper.
Consider the following two tables and four queries in SQL. Book (isbn, bname), Stock (isbn, copies) Query 1: SELECT B.isbn, S.copies FROM Book B INNER JOIN Stock S ON B.isbn = S.isbn;   Query 2: SELECT B.isbn, S.copies FROM Book B LEFT OUTER JOIN Stock S ON B.isbn = S.isbn; Query 3: SELECT B.isbn, S.copies FROM Book B RIGHT OUTER JOIN Stock S ON B.isbn = S.isbn;   Query 4: SELECT B.isbn, S.copies FROM Book B FULL OUTER JOIN Stock S ON B.isbn = S.isbn;   Which one of the queries above is certain to have an output that is a superset of the outputs of the other three queries?
The job of total length 300mm is tapered turned on lathe using tailstock set over method. The two diameters obtained are 80mm and 500mm and length of taper was 200mm only. Tail stock set over is equal to
A job of total length 800mm is tapered turned on lathe using tailstock set over method. The two diameters obtained are 450mm and 500mm and length of taper was 700mm only. Tail stock set over is equal to
Given:
Stock turnover 6 times
Total Sales Rs. 3,00,000
Gross profit Ratio 20%
Closing stock is Rs. 4,000 more than the opening stock. The opening stock will be: