Bissoy.com
Doctors Medicines MCQs Q&A

In oblique cutting of the metals, the cutting edge of the tool is

In oblique cutting of the metals, the cutting edge of the tool is Correct Answer inclined at an angle less than 900 to the direction of tool travel

The chip flows on the tool face at an angle of less than 900 with the normal on the cutting edge.

Related Questions

Consider the following statements: 1. HSS tools wear very rapidly, whereas in cemented carbide tools, even though hardness is retained, crater wear can occur due to solid-state diffusion. 2. Cutting tools made of Super-HSS, also known as cobalt-based HSS, are made by adding 2% to 15% of cobalt which increases the cutting efficiency at heavier cuts by increasing the hot hardness and wear resistance. 3. Tools failure due to excessive stress can be minimized by providing small or negative rake angles on brittle tool materials, protecting tool tip by providing large side-cutting edge angles, and honing a narrow chamfer along the cutting edge. Which of the above statements are correct?
Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting? 1. Force exerted by the tool on the chip acting normally to the tool face 2. Horizontal cutting force exerted by the tool on the workpiece 3. Frictional resistance of the tool against the chip flow acting along the tool face 4. Vertical force which helps in holding the tool in position Select the correct answer using the codes given below.
Flank wear occurs mainly on the 1. Nose part of the cutting tool 2. Front relief face and side relief face of the cutting tool 3. Face of the cutting tool at the shortest distance from the cutting edge Which of the above is/are correct?
In oblique cutting of metals, the cutting edge of the tool is
In oblique cutting system, the cutting edge of the tool
Angle between side cutting edge and end cutting edge in the top surface plane of tool.
In choosing a research tool which of the following are important considerations? A. The validity of the research tool B. The reliability of the research tool C. cost involved in terms of time and resources for use of research tool. D. Face validity of the research tool E. Opinion of the research supervisor Select the correct answer from the following options:
 If a cutting tool is designated as 0° - 10° - 6° - 6° - 8° - 75° - 1 inch, what is the side cutting edge angle of the tool
What are the two basic ways of metal cutting using a single-point cutting tool and a multi-point cutting tool?
G = (V, E) is an undirected simple graph in which each edge has a distinct weight, and e is a particular edge of G. Which of the following statements about the minimum spanning trees (MSTs) of G is/are TRUE? I. If e is the lightest edge of some cycle in G, then every MST of G includes e II. If e is the heaviest edge of some cycle in G, then every MST of G excludes e