The concrete members which are prestressed by providing the tensioned tendons are termed as ___________

The concrete members which are prestressed by providing the tensioned tendons are termed as ___________ Correct Answer Internally prestressed members

The concrete member which is prestressed by providing the tensioned tendon are termed as internally prestressed members and the existing space between the edge of beam and abutments is filled with concrete using expanding cement.
Bissoy MCQ

Related Questions

The concrete members which are prestressed by providing the tensioned tendons are termed as ____________
A post tensioned cable of beam 10m long is initially tensioned to a stress of 1000n/mm2 at one end, slope is 1 in 24 tendons curved at each end , area is 600mm2, Es is 210kn/mm2, coefficient of friction between duct and cable is 0.55, friction coefficient for wave effect is 0.0015perm. During anchorage, if there is a slip 3mm at the jacking end, calculate final force?
A prestressed concrete beam, 200mm wide and 300mm deep is prestressed with wires (area is 320mm2) located at a constant eccentricity of 50mm, initial stress of 1000n/mm2, span is 10m. Calculate loss of stress due to friction and slip anchorage of post tensioned beam?(Es = 210kn/mm2, Ec = 35kn/mm2).
The failure of prestressed concrete member without additional un tensioned reinforcement, to that of plain concrete is?
A post tensioned concrete beam, 100mm wide and 400mm deep is prestressed by three cables, each with a cross sectional area of 50mm2, initial stress of 1200n/mm2. Calculate the stress in concrete at level of steel?
The pre and post tensioned members with bonded tendons bond stress between ____________
The tendons in the pretensioning system are tensioned between ___________
In the anchorage zone or the end block of a post tensioned prestressed concrete element, the state of stress distribution is considered as ____________
A pre tensioned beam is prestressed with the cube strength of concrete at transfer is 30n/mm2 (β = 0.0235) calculate the transmission length?
The cross section of a prestressed concrete beam is 100mm wide and 300mm deep and the initial stress in tendons are located at a eccentricity of 50mm is 1000n/mm2, the sectional area is 100mm2. Find rotation due to prestress (hogging moment)?