Related Questions

From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
Which of the following statements regarding stress related factors is/are true and false?
1. Burnout Stress Syndrome (BOSS) is a debilirating psychological condition brought about by unrelieved work stress.
2. 'Good' and 'bad' stresses are also referred to as 'Distress' and 'Eustress' respectively.
3. It is natural and healthy to maintain optimal level of stress.
4. Rustout Stress Syndrome (ROSS) is indicative of stress overload.
5. Anxiety is a state of emotional tension characterised by Apprehension, fearfulness, and psychic pain.
In the case of 3-dimension state of stress, if one of the stress values, say, principal stress direction becomes compressive, the fracture stress reduces significantly.
When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor and W = Axial compressive load on the spring)
An axial residual compressive stress due to a manufacturing process is present on the outer surface of a rotating shaft subjected to bending. Under a given bending load, the fatigue of the shaft in the presence of the residual compressive stress is ____________
Calculate minimum wall thickness given a cylindrical prestressed water tank of internal diameter 30m over a depth of 7.5m and the permissible compressive stress at transfer is 13n/mm2 and the maximum compressive stress under working pressure is 1n/mm2 and the loss ratio is 0.75?
"It is now expected that the variable production cost per unit and the selling price per unit will each increase by 10%, and fixed production cost will rise by 25%. What will be the new break even point?
Selling price - Rs 6 per unit
Variable production cost - Rs 1.20 per unit
Variable selling cost - Rs 0.40 per unit
Fixed production cost - Rs 4 per unit
Fixed selling cost - Rs 0.80 per unit
Budgeted production and sales for the year are 10,000 units."
If compressive yield stress and tensile yield stress are equivalent, then region of safety from maximum principal stress theory is of which shape?