Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

If the specimen is deformed plastically beyond the yield stress in one direction, e.g., tension and then after unloading it is loaded in the opposite direction, e.g., compression, it is found that the yield stress is less than the original yield stress. This dependence of yield stress on direction loading is called ____________
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where $$\sigma $$ = Stress for a plate with no hole i.e. nominal stress)
Which of the following statement is not true considering a cubic lattice system? are not perpendicular to each other b) Direction is parallel to plane (hkl), when uh+vk+wl=0 c) Direction is perpendicular to the plane (hkl) when u=h, v=k, w=l d) Two planes (hkl) and (abc) are perpendicular to each other if h=a, k=b, l=c
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
Which of the following statements regarding stress related factors is/are true and false?
1. Burnout Stress Syndrome (BOSS) is a debilirating psychological condition brought about by unrelieved work stress.
2. 'Good' and 'bad' stresses are also referred to as 'Distress' and 'Eustress' respectively.
3. It is natural and healthy to maintain optimal level of stress.
4. Rustout Stress Syndrome (ROSS) is indicative of stress overload.
5. Anxiety is a state of emotional tension characterised by Apprehension, fearfulness, and psychic pain.
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
A wall bracket is attached to the wall by means of 2 identical bolts, one at A and one at B. The force of 20kN acts at a distance of 400mm. Bolt A lies at a distance of 50mm from axis of tilt and bolt B 500mm. Allowable shear stress in the bolts is 100N/mm² and tensile is 40N/mm². Find the radius of Mohr circle which can be made from the shear stress and tensile stress acting on bolts.(Consider bolt under max stress and area of bolt is A)
The normal stress is perpendicular to the area under considerations, while the shear stress acts over the area.
A rigid body is rotating about an axis. One force F1 acts on the body such that its vector passes through the axis of rotation. Another force F2 acts on it such that it is perpendicular to the axis of rotation and at a point 5cm from the axis. This force F2 is perpendicular to the radius vector at its point of application. Find the net torque on the body. Let F1 = 10N & F2= 5N.