Bissoy.com
Doctors Medicines MCQs Q&A

The working principles used for the working of wet scrubbers are similar to another particle collector. Which of the following is the particulate collector in question?

The working principles used for the working of wet scrubbers are similar to another particle collector. Which of the following is the particulate collector in question? Correct Answer Filters

The principles on which the wet scrubbers operate are inertial impact, interception, and diffusion. The same working principles are applied to filters, especially packed filters. The other listed devices run on different working principles.

Related Questions

Which of the following types of particulate matter pollutants are used in the calculation of the Air Quality Index (AQI)? (A) TSP (Total Suspended Particles) (B) PM 10 (Particulate matters of size 10 micron or less) (C) PM 2.5 (Particulate matter of size 2.5 micron or less) (D) PM 1 (Particulate matter of size 1 micron or less) Choose the correct answer from the options given below:
Wet scrubbers work based on several principles. Which of the following is not one of its principles?
Which particle sizes are collected primarily by inertial impact in wet scrubbers?
A, B, C, D, K, L, M and O are researchers and are working in three different institutes, X, Y and Z. They are working in three different areas namely, solar energy, sustainable development, and rainwater harvesting for agricultural purpose. Not less than two or more than three researchers are working in the same area and not more than three of them are working the same institute. K is researching in the sustainable development in the institute Y with B who is doing research in rainwater harvesting. A and M are doing research in the same area but not in sustainable development and are not working in the institute Y. C is researching in solar energy in the institute Z, only with D who is working in sustainable development. L is researching in rainwater harvesting area and not working in the institute where A works. O is not doing research in the solar energy. Choose option for answering question, In which of the institute/institutes at least one researcher is working in the area of solar energy ?
Which of the following statements is/are correct regarding the Directive Principles of the State Policy? A. In case of a conflict between the Directive Principles and Fundamental Rights, the Directive Principles shall prevail in the court. B. Fundamental rights are not unlimited and citizens are subject to reasonable restrictions. The Directive Principles are subject to any constitutional limitations.
What is the particulate cut diameter for the centrifugal scrubbers?
Shear stress versus shear rate behavior of four different types of fluids (I, II, III and IV) are shown in the figure below.
Basic Principles of Biotechnology mcq question image
Which one of the following options is correct?
In the following question below some statements are given followed by some conclusions. Taking the given statements to be true even if they seem to be at variance from commonly known facts, read all the conclusions and then decide which of the given conclusions logically follows the given statements. Statements: All smug is dust All dust is sand No sand is wet Conclusion: I. Some smug can be wet II. No wet is dust
For transistor action (a) Base, emitter, and collector regions should have similar size and doping concentrations. (b) The base region must be very thin and lightly doped. (c) The emitter-base junction is forward biased and the base-collector junction is reverse biased. (d) Both the emitter-base junction as well as the base-collector junction are forward biased. Which one of the following pairs of statements is correct?
A dryer is used for drying pears which has initial moisture content of 70 % (wet basis) and final moisture content of 5 % (wet basis). An experimental drying curve for the product indicates that the critical moisture content is 25 % (wet basis) and the time for constant drying is 5 min. Can you estimate the total drying time for product?