Bissoy.com
Doctors Medicines MCQs Q&A

What is an advantage of the impeller collector cyclone?

What is an advantage of the impeller collector cyclone? Correct Answer Low space requirement

In the case of the impeller-collector type cyclone, its main advantage is its space requirement, which is low. The system uses an impeller, which throws the particles outwards; these particles are then collected.

Related Questions

Consider the following statements pertaining to centrifugal pumps: 1. The inlet to the impeller of a centrifugal pump is always axial, while the outlet may be radial or inclined. 2. The impeller may be shrouded on both sides with an eye at the center and vanes curved backward. 3. Impeller of double-entry type has a balanced radial thrust. 4. Un-shrouded and part-shrouded impeller are used only where high efficiency is unimportant. Which of these statements are correct?
For a narrow base PNP BJT, the excess minority carrier concentrations (ΔnE for emitter, ΔpB for base, ΔnC for collector) normalized to equilibrium minority carrier concentrations (nE0 for emitter, pB0 for base, nC0 for collector) in the quasi-neutral emitter, base and collector regions are shown below. Which one of the following biasing modes is the transistor operating in?
For transistor action (a) Base, emitter, and collector regions should have similar size and doping concentrations. (b) The base region must be very thin and lightly doped. (c) The emitter-base junction is forward biased and the base-collector junction is reverse biased. (d) Both the emitter-base junction as well as the base-collector junction are forward biased. Which one of the following pairs of statements is correct?
Given collector resistance = 2kΩ, load resistance = 5kΩ, collector capacitance = 1μF, emitter capacitance = 20μF, collector current = 2mA, source resistance = 2kΩ. If the effect of blocking capacitor is ignored, find the applicable cut-off frequency.
Given that the collector power dissipation is 300 mW, what is the value of collector current for the collector to emitter voltage = 12 V?
Given that the collector power dissipation is 300 mW, what is the value of collector to emitter voltage for collector current = 50 mA?
Choose the right option among the alternatives – A transistor conducts in its forward direction when its collector/emitter/base, is positive with respect to its collector/emitter/base, and when a turn-on voltage or current signal is applied to its collector/emitter/base.
What advantage does polymer collector have over metal collector?
Consider a centrifugal pump having a specific impeller diameter, fixed impeller speed pumping a liquid of constant density at a particular discharge capacity. With decrease in the capacity of the pump, the __________ decreases.
Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)