Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The influence of shape of aggregate in strength and workability of concrete are given below in statements S1, S2, S3 and S4. Which of the statements are correct? S1: Rounded aggregate produces concrete with high workability and low strength. S2: Angular aggregate produces concrete with high workability and low strength. S3: Rounded aggregate produces concrete with low workability and high strength. S4: Angular aggregate produces concrete with low workability and high strength.
Study the following statements regarding creep.
i) Creep is greater on curves than on tangent railway track
ii) Creep in new rails is more than that in old rails
iii) Creep is more on steep gradients than on level track
The correct answer is
Permeability in concrete is studied towards providing for, or guarding against, which of the following features? 1. The penetration by materials in solution may adversely affect the durability of concrete; moreover, aggressive liquids 'attack' the concrete. 2. In the case of reinforced concrete, ingress of moisture and air will result in corrosion of steel leading to an increase in the volume of steel, resulting in cracking and swilling of the concrete cover. 3. The moisture penetration depends on permeability and if the concrete can become saturated with water it is less vulnerable to frost action.
Consider the following statements: 1. If more water is added to concrete for increasing its workability, it results into concrete of low strength. 2. No slump is an indication of a good workable concrete. 3. Higher the slump of concrete, lower will be its workability. 4. Workability of concrete is affected by water content as well as water-cement ratio. Which of the above statements are correct?
Which of the following statements describe(s) limitation(s) of concrete technology? A. Availability of concrete ingredients easily. B. Due to low tensile strength, concrete is required to be reinforced to avoid cracks. C. Monolithic character gives better appearance D. The property of concrete possesses high compressive strength.
Calculate ultimate moment and shear of effective span is 30m, live load is 9kn/m, dead load excluding self weight is 2kn/m, load factors for dead load is 1.4 for live load is 1.6 cube strength of concrete fcu is 50n/mm2 cube strength at transfer is fci is 35n/mm2, tensile strength of concrete Ec is 34kn/mm2 loss ratio ɳ is 0.85 and 8mm diameter high tensile strength fpu is 1500n/mm2 are available for use and the modulus of elasticity of high tensile wires is 200kn/mm2?
With regard to the characteristic strength of concrete, consider the following statement: “Test strength of samples means the average strength of X samples. The strength of a sample should not vary by more than ± Y% of the average strength. What will be the values of X and Y here?
A concrete beam of rectangular section 100mm wide, area is 3×104, initial stress is 1200n/mm2 of 7mm diameter located at an eccentricity 50mm. Estimate the loss of stress due to creep of concrete using the ultimate creep strain method?
The following statements (S1, S2, S3) pertain to mass concreting. Which of the following statements are correct? S1: The materials preferred for mass concrete are: Portland cement with low heat of hydration, Pozzolanas, Aggregates (coarse and fine), Water, Admixture, Coolants. S2: Slump of mass concrete shall be the same or more than ordinary concrete work. S3: Concrete with a low water cement ratio, correctly consolidated and properly cured provides durability to mass concrete work.
Consider the following statements related to the advantages of concrete sleepers : 1. Concrete sleepers can generally be mass-produced using local resources. 2. Concrete sleepers are not suitable for better packing. 3. Concrete sleepers have a very long life span. 4. Concrete sleepers have no scrap value. Which of the above statements is/are correct?