Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following is an integral part of the theodolite and is mounted on a spindle known as a horizontal axis?

Which of the following is an integral part of the theodolite and is mounted on a spindle known as a horizontal axis? Correct Answer Telescope

The telescope is an integral part of the theodolite. It is mounted on a spindle known as a horizontal axis or trunnion axis.

Related Questions

A displacement sensor (a dial indicator) measures the lateral displacement of a mandrel mounted on the taper hole inside a drill spindle. The mandrel axis is an extension of the drill spindle taper hole axis and the protruding portion of the mandrel surface is perfectly cylindrical measurements are taken with the sensor placed at two positions P and Q as shown in the figure. The readings are recorded as Rx = maximum deflection minus minimum deflection, corresponding to sensor position at X, over one rotation. If RP = RQ > 0, which one of the following would be consistent with the observation?
The horizontal angle subtended at the theodolite station by a subtense bar with vanes 3 m apart is 0o 10 ′40′′. Calculate the horizontal distance between the theodolite and the subtense bar?
A semicircular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi circular disc and horizontal surface is µ. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will
A semi-circular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi-cricular disc and horizontal surface is i. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will
For helical gears, the angle between hob’s spindle axis and workpiece’s spindle axis must be _____ as the helix angle of the helical gear.
In the process of gear cutting by hobbing, the angle between the hob’s spindle axis and the workpiece’s spindle axis is fixed.
For spur gear manufacturing, angle between the hob’s spindle axis and the workpiece’s spindle axis should be equal to____
The disk platters mounted on a spindle and the heads mounted on a disk arm are together known as ___________
According to parallel axis theorem, the moment of inertia of a section about an axis parallel to the axis through center of gravity (i.e. $$I$$P) is given by (where, A = Area of the section, $$I$$G = Moment of inertia of the section about an axis passing through its C.G. and h = Distance between C.G. and the parallel axis.)
According to parallel axis theorem, the moment of inertia of a section about an axis parallel to the axis through center of gravity (i.e. $${I_{\text{P}}}$$) is given by (where, A = Area of the section, $${I_{\text{G}}}$$ = Moment of inertia of the section about an axis passing through its C.G. and h = Distance between C.G. and the parallel axis.)