Bissoy.com
Doctors Medicines MCQs Q&A

The connection of intermediate transverse stiffeners are designed for shear of

The connection of intermediate transverse stiffeners are designed for shear of Correct Answer tw2/5bs

Intermediate transverse stiffeners not subjected to external loading should be connected to the web so as to withstand a shear between each component of the stiffener and the web not less than tw2/5bs, where tw is thickness of web, bs is outstand width of stiffener.

Related Questions

As per IS 800 ∶ 2007, in the design of beams/plate girders, when the web of a member acting alone is inadequate, different types of stiffeners are provided. Match the type of stiffeners provided in List I with the requirement to be satisfied by them in List 2. (Use the Code in the lists for matching). List 1 List 2 B. Intermediate transverse web stiffener 1. Provide local reinforcement to web under shear and bearing. C. Load carrying stiffener 2. Improve the buckling strength of a slender web due to shear. D. Bearing stiffener 3. Prevent local buckling of web due to concentrated loading. E. Diagonal stiffener 4. Prevent local crushing of web due to concentrated loading
The connection of intermediate vertical stiffeners to the web, not subjected to external loads, shall be designed for a minimum shear force (kN/m) of(where, t = the web thickness in mm h = the outstand of stiffener in mm)
The connection of intermediate vertical stiffeners to the web, not subjected to external loads, shall be designed for a minimum shear force (kN/m) of
(where, t = the web thickness in mm h = the outstand of stiffener in mm)
Consider two shafts connected with two gears as per the following options: 1. One on each shaft 2. Through an intermediate gear mounted on an intermediate shaft, and every shaft having one gear only 3. Through an intermediate gear mounted on an intermediate shaft, with the intermediate shaft having two gears, whereas the other shafts have one gear each Which of the above represent(s) a simple gear train?
The depth-to-thickness ratio of web when only transverse stiffeners are provided and 3d ≥ c ≥d, where c is clear distance between stiffeners and d is depth of web is_____ to meet serviceability criteria
The depth-to-thickness ratio of web when only transverse stiffeners are provided and c < 0.74d, where c is clear distance between stiffeners and d is depth of web is_____ to meet serviceability criteria
Consider the following statements: In a plate girder 1. Bearing stiffeners are designed for bearing forces and they must also be checked for safety against compressive forces. 2. The length of any staggered intermittent fillet weld should not be less than 10 times the thickness of the stiffener. 3. Bearing stiffeners must be provided at the point of maximum bending moment. Which of the above statements are correct?
The transverse shear stress acting in a beam of rectangular cross-section, subjected to a transverse shear load, is ____________
Consider the following two statements regarding Bearing stiffeners provided at the location of a concentrated load: 1. Bearing stiffeners have to resist bearing and buckling loads. 2. Bearing area and the area resisting buckling load are the same. Which of the above statements is/are correct ?
The effective length of web on each side of centreline of stiffeners for interior stiffeners is limited to