Bissoy.com
Doctors Medicines MCQs Q&A

When cantilever beam is supported by girder, the end of cantilever will transfer

When cantilever beam is supported by girder, the end of cantilever will transfer Correct Answer shear force and bending moment

When cantilever beam is supported by girder, the end of cantilever will transfer shear force and bending moment and this bending moment will be transferred to primary beam as torsion.

Related Questions

Consider the following statements regarding types of supports and beams: 1. When both supports of beams are roller supports, the beam is known as simply supported beam. 2. A beam with one end fixed and the other end free is known as fixed beam. 3. A beam with both ends fixed is known as cantilever beam. 4. A beam with one end fixed and the other simply supported is known as propped cantilever. Which of the above statements is/are correct ?
In which of the following cases, there exists the situation of Pure Bending in some part of the beam or along the entire beam? i) A simply supported beam subjected to two equally spaced downward concentrated loads ii) A simply supported beam subjected to two equally spaced opposite moments iii) A cantilever beam subjected to clockwise moment at free end iv) An overhanging beam with both side overhangs subjected to different concentrated loads at both the free ends
Consider the following statements with regards to the shear force diagram for the beam ABCD: 1. The beam ABCD is an overhanging beam having supports at A and D only. 2. The beam carries a point load of 20 kN at C. 3. The beam carries a concentrated load of 10 kN at the end B. 4. The beam is an overhanging beam having supports at C and D only. 5. The beam carries a uniformly distributed load of 70 kN over the left hand portion AC only. Which of the above statements are correct?
Consider the following statements: 1. The thickness of the gusset plate should not be more than the thickness of the structural members being connected. 2. A plate girder is essentially a beam and its moment of resistance depends upon its section modulus. 3. The function of the flanges in a plate girder is to resist the bending moment and hence their respective areas can be reduced near the supports of a simply supported beam. Which of the above statements are correct?
A 2 m long beam BC carries a single concentrated load at its mid span and is simply supported at its end by two cantilevers AB = 1m long and CD = 2m long as shown in figure. The shear force at end A and bending moment at end D of the cantilever, respectively will be -
The adjoining figure shows a schematic representation of a steel plate girder to be used as a simply supported beam with a concentrated load. For stiffeners, PQ (running along the beam axis) and RS (running between the top and bottom flanges) which of the following pairs of statements will be TRUE?
A uniformly distributed load w (kN/m) is acting over the entire length of 8 m long cantilever beam. If the shear force at the midpoint of cantilever beam is 12 kN. What is the value of w?
A simply supported beam 'A' of length l, breadth b, and depth d carries a central point load W. Another beam 'B' has the same length and depth but its breadth is doubled. The deflection of beam 'B' will be __________ as compared to beam 'A'.
Consider the following statements regarding continuous beam: 1. A beam is said to be a continuous beam if it is supported on more than two supports. 2. A continuous beam is a statically indeterminate structure. 3. The degree of indeterminacy depends upon the number of supports and also on the nature of the supports. Which of the above statements are correct?
A simply supported beam 'A' of length ‘l’, breadth ‘b’ and depth ‘d’ carries a central load ‘W’. Another beam 'B' of the same dimensions carries a central load equal to 2W. The deflection of beam 'B' will be __________ as that of beam 'A'.