Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)
Which of the following assumptions are made in the design of rivet joints? A. Rivets are stressed equally B. Stress in plate is maximum at mid-width C. Rivet hole is completely filled by rivet D. Friction between plates is neglected
In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)
In order to avoid tearing off the plate at an edge, the distance from the center of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm)
According to Indian standards, the diameter of rivet hole is made larger than the basic size of rivet by
Pipe A along with a hole can fill a tank in 20 minutes, pipe B along with hole can fill that tank in 1 hour. If both the pipes along with hole can fill that tank in (60/7) minutes, then what is the time taken by hole alone to empty that tank completely?
In this question, a passage and a related statement have been given. Read the passage carefully and assess the statement based on it. Using knives and screws, two Russian astronauts on Tuesday took a sample of substance around a mysterious cavity of the spacecraft called the Soyuz, which was placed in the International Space Station, a Moscow official suggested that it was a break - It can also be done. In August, two months after the last visit of the vehicle, the air leak was detected in the Soyuz spacecraft due to the 2 mm air in the ISS. Roskosmos, an astronomical institute, says that cutting off the insulation on the hole and sampling the material around it and the purpose of putting a new insulation on it is to find out that this small but dangerous hole has been done on earth or Is in space. The chief of Roskosmos has said that the error of manufacturing has not been found in the investigation. Experienced astronauts had to struggle but they managed their mission. Before the spacewalk, astronauts were able to inspect the hole just from within the spacecraft. The biggest difficulty was that in the Soyuz spacecraft, the ISS was not designed to improve during adverse weather space, and no railing was also made to catch the space passengers outside the vehicle. Statement: The mysterious hole in the So yuz spacecraft was due to the error of manufacturing. Select the appropriate from the given options A - Statement is completely true B - The statement is possibly true C - the statement can not be determined D - Statement is completely false
For manufacturing of a certain amount of hole, maximum hole size was found to be 50.14 mm and minimum hole size was found to be 49.98. What will be the Tolerance in mm?
For manufacturing of a certain amount of hole, maximum hole size was found to be 50.14 mm and minimum hole size was found to be 49.98. Tolerance in mm will be
In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia. of rivet d should be equal to