In reinforced brick masonry, the reinforcement is laid only horizontally.

In reinforced brick masonry, the reinforcement is laid only horizontally. Correct Answer False

In reinforced brick masonry, the reinforcement can be laid both horizontally or vertically. In horizontal reinforcement, bars are placed in such a way that they go all the way through the wall while in vertical reinforcement, vertical steel bars are placed at all the corners of the walls.
Bissoy MCQ

Related Questions

Consider the following statements regarding bands to be provided for strengthening masonry work in masonry buildings constructed in zone III, IV and V.
(i) Lintel band is provided at lintel level on partition walls,
(ii) Gable band is provided at top of gable masonry below the purlins,
(iii) The bands shall be to full width of the wall and not less than 7.5 cm in depth,
(iv) The bands shall be made of reinforced concrete only.
of these statements, the correct statements are
The method of moving each brick through a small horizontal distance before it is finally laid in any brick wall and pressing it by means of brick hammer, is known as
The furnace of a boiler is laid from fire clay brick with outside lagging from the plate steel, the distance between the two is quite small compared with the size of the furnace. The brick setting is at an average temperature of 365 K whilst the steel lagging is at 290 K. Calculate the radiant heat flux. Assume the following emissivity values For brick = 0.85 For steel = 0.65
__________ masonry occupies an intermediate position between rubble masonry and ashlar masonry.
______ type of ashlar masonry occupies an intermediate position between the rubble masonry and ashlar masonry.
In stone composite masonry, ashlar masonry is used in backing of the wall while rubble masonry is used in the facing.
Consider the following statements:
(i) Masonry in rich cement mortar though having good strength with high shrinkage is much liable for surface cracks.
(ii) Lime mortar possesses poor workability and poor water retentivity and also suffers high shrinkage.
(iii) Masonry in lime mortar has better resistance against rain penetration and is less liable to crack when compared to masonry in cement mortar.
Which of these statements are correct?
The term ___________ in construction is applied to the finishing of mortar joints in masonry (stone or brick). In exposed masonry, these are considered to be the weakest part.
The term ______________ is used to denote the finishing of mortar joints of either stone masonry on Brick masonry.
If the main reinforcement of the slab is parallel to a T-beam, the transverse reinforcement at mid span of the slab is provided at least __________ of main reinforcement.