Bissoy.com
Doctors Medicines MCQs Q&A

What is the suggested slenderness ratio for simply supported RCC decks?

What is the suggested slenderness ratio for simply supported RCC decks? Correct Answer 12 to 15

The height, thickness and spacing of buttresses can be controlled by Slenderness ratio. Slenderness ratio is the ratio of the height of the buttress to the thickness of the buttress. The value usually ranges from 12 to 15.

Related Questions

What is suggested massiveness factor for simply supported RCC Decks?
The natural frequency of free transverse vibrations due to uniformly distributed load acting over a simply supported shaft is (where $$\delta {\text{S}}$$ = Static deflection of simply supported shaft due to uniformly distributed load)
The natural frequency of free transverse vibrations due to a point load acting over a simply supported shaft is equal to (where $$\delta $$ = Static deflection of a simply supported shaft due to the point load)
Consider the following statements regarding types of supports and beams: 1. When both supports of beams are roller supports, the beam is known as simply supported beam. 2. A beam with one end fixed and the other end free is known as fixed beam. 3. A beam with both ends fixed is known as cantilever beam. 4. A beam with one end fixed and the other simply supported is known as propped cantilever. Which of the above statements is/are correct ?
In which of the following cases, there exists the situation of Pure Bending in some part of the beam or along the entire beam? i) A simply supported beam subjected to two equally spaced downward concentrated loads ii) A simply supported beam subjected to two equally spaced opposite moments iii) A cantilever beam subjected to clockwise moment at free end iv) An overhanging beam with both side overhangs subjected to different concentrated loads at both the free ends
There are two beams of equal length L and a load P is acting on centre of both beams. One of them is simply supported at both ends while the other one is fixed at both ends. Deflection of centre of simply supported beam will be __________ times that of defection of centre of fixed beam.
Assertion A : From consideration of structural soundness and economy of design, most codes control the maximum slenderness ratio of masonry walls and columns.Reason R : By controlling the maximum slenderness ratio, failure is by excessive stress and not by buckling. Select your answer according to codes given below:
Effective slenderness ratio of battened column shall be ____ of actual slenderness ratio of column
Assertion A : From consideration of structural soundness and economy of design, most codes control the maximum slenderness ratio of masonry walls and columns.
Reason R : By controlling the maximum slenderness ratio, failure is by excessive stress and not by buckling.
Select your answer according to codes given below:
A 200 mm thick wall made of modular bricks is 5 m long between cross walls and 3.8 m clear height between RCC slabs at top and bottom. The slenderness ratio of the wall is