Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statements with regards to the shear force diagram for the beam ABCD: 1. The beam ABCD is an overhanging beam having supports at A and D only. 2. The beam carries a point load of 20 kN at C. 3. The beam carries a concentrated load of 10 kN at the end B. 4. The beam is an overhanging beam having supports at C and D only. 5. The beam carries a uniformly distributed load of 70 kN over the left hand portion AC only. Which of the above statements are correct?
Consider the following statements regarding types of supports and beams: 1. When both supports of beams are roller supports, the beam is known as simply supported beam. 2. A beam with one end fixed and the other end free is known as fixed beam. 3. A beam with both ends fixed is known as cantilever beam. 4. A beam with one end fixed and the other simply supported is known as propped cantilever. Which of the above statements is/are correct ?
The slender beam used in benkleman beam method is ___________
In which of the following cases, there exists the situation of Pure Bending in some part of the beam or along the entire beam? i) A simply supported beam subjected to two equally spaced downward concentrated loads ii) A simply supported beam subjected to two equally spaced opposite moments iii) A cantilever beam subjected to clockwise moment at free end iv) An overhanging beam with both side overhangs subjected to different concentrated loads at both the free ends
The quantity of soil collected in benkleman beam method is ___________
The tyre pressure in benkleman beam method should be inflated to (in kg/cm2).
The least count of the small needle in benkleman beam test is ___________
Wheel load distribution in one side of benkleman beam test is ___________
Engines are rated at specified conditions. Then which of the following statements are correct? 1. Power developed increases as local temperature increases. 2. Power developed increases as local temperature decreases 3. Power developed is not dependent on local temperature. 4. Power developed increases as local atmospheric pressure increases. 5. Power developed increases as local atmospheric pressure decreases.
The rectangular beam 'A' has length ‘l’, width ‘b’ and depth ‘d’. Another beam 'B' has the same length and depth but width is double that of 'A'. The elastic strength of beam 'B' will be _________ as compared to beam ‘A’.