Bissoy.com
Doctors Medicines MCQs Q&A

In site exploration, depth up to which the increase in pressure is likely to cause shear failure is known as ___________

In site exploration, depth up to which the increase in pressure is likely to cause shear failure is known as ___________ Correct Answer Significant depth

Exploration in general, should be carried out to a depth up to which the increase in pressure due to structural loading is likely to cause perceptible failure or shear failure. Such a depth is known as the significant depth.

Related Questions

Consider the following statements associated with local shear failure of soils: 1. Failure is sudden with well-defined ultimate load. 2. This failure occurs in highly compressible soils. 3. Failure is preceded by large settlement. Which of these statements are correct ?
Match the following in Column X with Column Y: Column X Column Y  P. In a triaxial compression test, with increase of axial strain in loose sand under drained shear condition, the volumetric strain  I. decreases  Q. In a triaxial compression test, with increase of axial strain in loose sand under undrained shear condition, the excess pore water pressure  II. Increase  R. In a triaxial compression test, the pore pressure parameter “B” for a saturated soil  III. remains same  S. For shallow strip footing in pure saturated clay, Terzaghi’s bearing capacity factor (Nq) due to surcharge  IV. is always 0.0.      V. is always 1.0.      VI. is always 0.5. Which one of the following combinations is correct?
Which set of the following events occurs during the elongation step of translation?
P. Attachment of mRNA with the smaller subunit of ribosome
Q. Loading of correct aminoacyl-tRNA into the A site.
R. Formation of a peptide bond between the amino acyl-tRNA in the A site and the peptide chain that is attached to the peptidyl-tRNA in the P site.
S. Dissociation of the ribosomal subunits.
T. Translocation of peptidyl-tRNA from the A site to the P site of the ribosome.
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
Consider the following provision in Section 300 of the Indian Penal Code:
Several culpable states of mind are referred to with the:
1. intention to cause death
2. knowledge that the act is so imminently dangerous that it must in all probability cause death
3. intention to cause such bodily injury as the offender know to be likely to cause death of the person to whom harm is caused
4. intention of causing such bodily injury as is sufficient in ordinary course of nature to cause death.
The correct order of the sequence in which they are placed in the provision is:
Which one of the following sets is incorrect to show the inter-relationships among price elasticity coefficient, change in price and change in total revenue ? Price elasticity coefficient Change in price Change in Total Revenue 1) Zero Increase Decrease Increase Decrease (2) Less than 1 Increase Decrease Decrease Increase (3) Equal to 1 Increase Decrease No change No change (4) More than 1 Increase Decrease Decrease Increase  
Each material circumstance appearing in evidence against the accused must be put to the accused specifically, distinctly and separately. In this context, the propositions are
1. Failure to put the material evidence to the accused always vitiates the trial
2. Failure to put the material evidence amounts to a serious irregularity which can not be cured and vitiates the trial, if it has prejudiced the accused.
3. Failure to put the material evidence is not considered to services & is curable if infact no failure of justice has occasioned to the accused.
Now which of the following is correct
Consider the following statements regarding typical analysis of bolt failure :  1. 15% failure of bolt occur at the fillet under the head. 2. 50% failure of bolt occur at the end of threads on the shank. 3. 80% failure of bolt occur in the threads that are in contact with the nut. Which of the above statements is/are correct ?
The variance of failure time (time to failure) of an electric motor in shovel is 1600 hr2. If the failure time follows an exponential distribution. the expected mean time between failure in hr is
Which of the following factors are affecting critical shear stresses? 1. Purity of metals reduces the critical shear stress 2. Surface films greatly enhance the critical shear stress 3. Rise in temperature 4. Rate of deformation and the extent of initial deformation also help in raising the critical shear stress