Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Read the given statements and conclusions carefully. Assuming that the information given in the statements is true, even if it appears to be at variance with commonly known facts, decide which of the given conclusions logically follow(s) from the statements. Statements: I. All go downs are warehouses. II. Some warehouses are buildings. Conclusions: I. No building are warehouses II. Some go downs are building.
Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?
In a suit for partition, a Memorandum of Family Settlement is filed and on this basis the partition suit is decreed, but even after disposal of the suit the original Memorandum of Family Settlement remains in the file of the partition suit, then in such situation whether in a suit for eviction by one of the original co-owner of a tenant of a shop of the joint property which has fallen to the share of that co-owner as per the decree passed on the Memorandum of Family Settlement, can the certified copy of the Memorandum of Family Settlement be filed and proved as a public document in the suit against the tenant?
Reading the amended Section 89 of the Code of Civil Procedure and the insertions of O. 10, which of the following conditions should be satisfied before matter could be referred to an Alternate Dispute Redressal?
1. Existence of elements of settlement in the opinion of the Court
2. The parties must share the opinion of the court
3. Formulation of the terms of settlement by the court
4. The court should invite the observation of the parties on the terms of settlement
5. Observations of the parties must be received by the court
6. If need be, reformulate the terms of settlement and refer the same for Alternate Dispute Redressal contemplated un section 89 of the Code of Civil Procedure
Under section 89 the court shall formulate the terms of settlement and give them to the parties for their observations and after receiving the observations of the parties, the court may reformulate the terms of possible settlement and the same for:
1. Arbitration
2. Conciliation
3. Judicial settlement including settlement through Lok Adalat
4. Mediation
In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed
Which of the following pairs is/are correctly matched? 1. Permanent Settlement : Lord Cornwallis 2. Ryotwari Settlement : Thomas Munro 3. Mahalwari Settlement : Holt Mackenzie Select the correct answer using the code given below.
H' and 'W' after a protracted legal entanglement decided to annual their marriage through divorce by mutual consent and it was agreed upon between them that 'H' would pay Rupees five crores only towards one time alimony as against permanent settlement of the claims between the parties. One of the stipulation of the settlement was that 'w' would not remarry for a period till the child who was given in custody of 'W' would attain the age of 30 years or else 'W' would be liable to refund the amount received as permanent alimony towards permanent settlement between the parties.
A fillet-welded joint is subjected to transverse loading F as shown in the figure. Both legs of the fillets are of 10 mm size and the weld length is 30 mm. If the allowable shear stress of the weld is 94 MPa, considering the minimum throat area of the weld, the maximum allowable transverse load per weld in kN is
Maximum allowable current for a 240-V DC shunt motor is equal to 65 A. Minimum allowable current for same is equal to 40 A. What will be the value of γ?