Bissoy.com
Doctors Medicines MCQs Q&A

The normal stress in y-direction in terms of effective stress is given by __________

The normal stress in y-direction in terms of effective stress is given by __________ Correct Answer σy= σy’+γw(h-he)

The total stress is equal to effective stress plus pore pressure. In y- direction, the normal stress is given by, σy= σy’+u u= γw(h-he) where, h=total head at the point he=elevation head ∴ σy= σy’+γw(h-he).

Related Questions

The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
Consider the following statements: 1. Effective stress in a sand layer below a lake with standing water does not alter as the water level fluctuates. 2. Regarding water table below the ground surface, any rise in the water table causes equal changes in both pore pressure and effective stress. 3. Capillary saturation will cause the effective stress to increase. Which of the above statements are correct?
Determine the shear strength of soil (in kN/m2 units) in terms of effective stress on a plane within a saturated soil mass at a point where the total stress is 220 N/m2 and the pore water pressure is 120 kN/m2. The effective stress shear strength parameters for the soil are: cohesion = 16 kN/m2 and angle of internal friction = 30 . (take sin 30 = 0.5, tan 30 = 0.6; cos 30 = 0.9)
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
The normal stress in x-direction in terms of effective stress is given by __________
The normal stress in z-direction in terms of effective stress is given by __________
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
Which of the following statements regarding stress related factors is/are true and false?
1. Burnout Stress Syndrome (BOSS) is a debilirating psychological condition brought about by unrelieved work stress.
2. 'Good' and 'bad' stresses are also referred to as 'Distress' and 'Eustress' respectively.
3. It is natural and healthy to maintain optimal level of stress.
4. Rustout Stress Syndrome (ROSS) is indicative of stress overload.
5. Anxiety is a state of emotional tension characterised by Apprehension, fearfulness, and psychic pain.
Consider a unit cube subjected to normal stress σx, σy, σz. Assume normal stress does not produce any shear stress on planes x, y, z. What will be the net strain along x direction? b) 1/E c) 1/E d) 1/E
What is the formula of virtual effective diameter in case of unified threads? . b) Simple effective diameter – . c) Simple effective diameter + . d) Simple effective diameter – .