Bissoy.com
Doctors Medicines MCQs Q&A

A clay specimen has an unconfined compressive strength of 240 Kn/m2 in a distributed state. On remolding, the unconfined compressive strength is 54 Kn/m2. What will be the sensitivity of clay?

A clay specimen has an unconfined compressive strength of 240 Kn/m2 in a distributed state. On remolding, the unconfined compressive strength is 54 Kn/m2. What will be the sensitivity of clay? Correct Answer 4.44

Sensitivity, St = QU(undistributed)/QU(distributed) =240/54 =4.44.

Related Questions

Consider a measuring system consisting of a sensor, an amplifier and an oscilloscope. The sensitivity of each equipment is as follows : Sensor sensitivity : 0.4 mV/°C, Amplifier gain : 5.0 V/mV, and Oscilloscope sensitivity : 10 mV/V. What is the sensitivity of complete measurement system ?
A rock specimen of 120 mm length and 54 mm diameter is subjected to uniaxial compressive loading. Two strain gauges, one axially and other radially, are attached to the specimen. At the breaking load, if these two gauges read 0.0082 m/m and 0.0023 m/m respectively, the Poisson's ratio of the specimen is
The ratio of uniaxial compressive strength to uniaxial tensile strength of a sandstone specimen is 8 : 1. The theoretical, value of angle of internal friction of the specimen in degree is
Compared to mild steel, cast iron has (i) High compressive strength (ii) High tensile strength (iii) Low compressive strength (iv) Low tensile strength
Compared to mild steel, cast iron has
(i) High compressive strength
(ii) High tensile strength
(iii) Low compressive strength
(iv) Low tensile strength
A construction firm has decided to use burnt clay bricks of class 20 and above (as per IS 1077 : 1992) for the construction of a residential complex. The table below gives the details of Samples with Id (S1, S2, S3, S4, and S5) taken from five different suppliers. The criteria to be adopted are the percentage of water absorption and average compressive strength of bricks corresponding to bricks of class 20 and above. Select the Id of the samples which can be recommended for use in brick wall construction. Id Water absorption (%) Average compressive strength (kN/m2) S1 18 17500 S2 20 21000 S3 12 20000 S4 10 14000 S5 15 27000
In a point load test on 50 mm diameter core specimen. rupture was observed at a load of 5000 kg. The uni-axial compressive strength of the specimen was
The below table provides the thermos-emf sensitivity of five materials with reference to platinum around 273 K. Material Constantan Nickel Copper Iron Nichrome Sensitivity (μVK-1) -35 -25 +6 +18.5 +25 Which one of the following thermocouple pairs has maximum sensitivity around 273 K?
Consider the following statements: 1. IS 3583 refers to Burnt Clay Paving Bricks. 2. IS 5779 refers to Burnt Clay Soling Bricks. 3. IS 3952 refers to Burnt Clay Hollow Bricks. 4. IS 2222 refers to Burnt Clay Lay Bricks. Which of the above statements are correct? 
Shallow or unconfined wells are completed in the uppermost saturated aquifer at that location (the upper unconfined aquifer).