Bissoy.com
Doctors Medicines MCQs Q&A

In TCBR, ________ firing control is used to damp low-frequency oscillations selectively.

In TCBR, ________ firing control is used to damp low-frequency oscillations selectively. Correct Answer half-cycle by half-cycle

In TCBR, half-cycle by half-cycle firing control is used to damp low-frequency oscillations selectively. However, to minimize the cost TCBR is sometimes thyristor switched but without firing angle control.

Related Questions

Which of the following is/are the advantages of using a control chart for inspection? (i) A control chart indicates whether the process is in control or out of control. (ii) A control chart determines process variability. (iii) A control chart ensures product quality. (iv) Scrap or percentage reduction can be reduced by taking the necessary actions in time against the warnings indicated by control charts. (v) Control charts build up the reputation of the organization through customer’s satisfaction. (vi) The control chart can detect the unusual variations taking place in a process.
TCBR can damp ________
Transmission angle control is NOT applied to damp power oscillations.
A sealed area known to have black damp has 18% O2, 2% CO2, and 78% N2. If fresh air has 21% O2, 0.03% CO2 and 78.97% N2, the percentage of black damp in the are is
Damped oscillations are those oscillations which ___________ continuously with time.
In the following question, the 1st and the last part of the sentence/passage are numbered 1 and 6. The rest of the sentence/ passage is split into four parts and named P, Q, R and S. These four parts are not given in their proper order. Read the sentence/passage and find out which of the four combinations is correct. 1. There was a lot of firing on the border. P. The security forces beefed up efforts and countered the firing. Q. The enemy faced a tough drilling from them. R. The situation at first was out of control. S. Thus, peace was restored temporarily along the adjoining areas. 6. The situation always remains tense.
If the RC firing circuit used for firing an SCR is to be used to fire a TRIAC then
(i) Low short circuit current is required in dc system (ii) Fast control of the converter switches cannot effectively control the damping of the oscillations. Choose the most appropriate.
Consider a control unit generating the control signals. These control signals are divided into five mutually exclusive groups as shown below: Groups  G1  G1  G1  G1  G1 Control  Signals   3  7  10  12  2 How many bits are saved using the Vertical Micro-programmed instead of Horizontal Micro-programmed control unit?
Examine the following statements about span of control and identify the ones which are true?
1. More task complexity requires narrower span of control.
2. Routine tasks can have greater span of control than exceptional tasks.
3. When tasks are dissimilar, then span of control can be larger.
4. Spans of control are generally narrower at the top and broader at the bottom of the hierarchy.